I had one similar a few months back but the perspex was all wavey.
This one is nice and clear, no hesitation using it, I also brought one for the passenger
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
as you can see it tucks up against the visor, folds forward.
I like it, picture taken from back seat
middle pic is green visor only
Right pic is both green and yellow visor,
but you can remove very easyly
Last edited by threedogs; 30th May 2014 at 03:55 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Bought a new steering coupling as the old one is cracked. Will get a gu steering box in the near future and fit it all up.
IMO and should be taken with a grain of salt.
4 x Cooper ST 285/75/R16's with probably just under half the tread on them for $150! Getting 4 new sunnies for them and they will be my roadies so I don't kill my 315 KM2's...
Gotta love it. My previous roadies I paid $399 for the five with rims around 18months ago. Done 50k on them and sold them last week for $400!!!! So they cost me nothing to run on....
I missed out on a great set on Coopers today but they were for 17's, 5 sold for under $200 with atleast 70percent tread, as I was contemplating getting some GUIV alloys. Not now....
Finally scored a maxtrax rear wheel carrier for the Simmo trip now I won't have to think of some other way to carry them.
2003 gu3 td42tdi sold 😞 bloody gvm towing crap. Bt50 3500kg gvm.
Bloodyaussie (6th June 2014)
I made a set of pins for a local bloke which go threw the holes on the tracks and mount to the roof rack sides.
He wanted his welded but no reason why you couldn't simply drill a hole threw top rail and use a long bolt.
Just drill a hole in the end for a ring pin or R clip or padlock to hold em on with and a bit or the foam floor matting spiked over the mounts behind the tracks to stop vibrations..
Cheers
Kallen Westbrook
IMG_490459529062140.jpeg
His were the green tracks, mounted above his rear passengers door..
Cheers
Kallen Westbrook
BigRAWesty (6th June 2014), mudski (6th June 2014)