Amelia is getting a new ass!!

[2TROLLFAM]

God bling is time consuming ... Slowly getting there

ImageUploadedByMotorculture1398567772.236188.jpg

[threedogs]

Just one question how far between the back of the cab till the Pod ??
Looked close on one picture but not bolted at that stage.

[FNQGU]

Might be too late, but I think I read in Cuppa's build thread something about the value in being able to look back through the pod over the drivers left shoulder and out the side when about to make a Left hand turn or lane change. My mate with a Toyota ute just put clears into his side canvas on that passengers side to help deal with the blind spot as well. Just a thought. Hope you already have it sorted.

[2TROLLFAM]

Just one question how far between the back of the cab till the Pod ??
Looked close on one picture but not bolted at that stage.

Same distance that the tray was - I just measured, roughly 70mm

[2TROLLFAM]

Might be too late, but I think I read in Cuppa's build thread something about the value in being able to look back through the pod over the drivers left shoulder and out the side when about to make a Left hand turn or lane change. My mate with a Toyota ute just put clears into his side canvas on that passengers side to help deal with the blind spot as well. Just a thought. Hope you already have it sorted.

Good point but yeah too late to change it. He's got extension arms for the side mirrors (not on yet) that also have those little round mirrors on them & a reverse camera that is planned to be used to see behind whilst driving (the monitor clips over existing rear vision mirror)

ImageUploadedByMotorculture1398578548.149642.jpg

ImageUploadedByMotorculture1398578594.853607.jpg

[2TROLLFAM]

wiring taking longer than anticipated - dodgy wiring on the ute to start with so making do for now but gonna replace it all another day. Just need to get it working cuz he goes back to work tomorrow after taking a week holidays

ImageUploadedByMotorculture1398578802.572888.jpg

[2TROLLFAM]

Threedogs

ImageUploadedByMotorculture1398579441.462163.jpg

[thebrod]

seriously impressive looking setup. I wish I had a fraction of those fabrication skills.

[threedogs]

Always good starting with a blank canvas and transforming it to suit your needs.
I think Cuppa had a camera high up on his pod as well,?
Nice touch with the edging, very swish indeed

[nissannewby]

I'm pretty sure it is but has brad colour coded it to the cab?

I will make something similar one day it will be a little shorter though to allow for some serious off road play.