Bent up Sill

[menace 2]

looks like the floor would be crimped also ?

[SKID]

looks like the floor would be crimped also ?

Floor doesnt look crimpled, when the side step got bent yo is crushed the bottom sill and pushed the top of it up and in a little..

[SKID]

How much would I be looking at for a replacement sil? and where would I begin looking around brisbane?
I know how to weld..

[megatexture]

Mate I'd be trying to weld on the slide hammer if that fails then try the pop rivets and if all fails cut it out and weld in.

[happygu]

Skid,

You can get the sill from a wreckers .....if you tell them where from and where too, they will cut you out a piece..... if you do this, get it from the door jamb seam, to the underneath seam, to try and join it at the factory joins

Just be aware, it is a fair job to cut and reweld ... not for the faint hearted, but if you have plenty of time have a go....

Mic

[04OFF]

This guys panel look nearlyas bad as mine, why is everyone saying make an insurance glaim? will cosy me 600 for the excess to start with.. rivits etc will cost alot less..

Yours is a fair bit worse old mate, for starters the damage has effected the lower area of your B pillar, keep in mind, looking at the pics from the other thread, im pretty sure the damaged sill has NOT been returned to its "factory" shape on the inside or the outside, like I said in my post earlier "All this also depends on what the car is worth, and how "fixed" you need it ?" so if that is as good a repair as you need, why not just follow down the same path ?

[SKID]

Mate I'd be trying to weld on the slide hammer if that fails then try the pop rivets and if all fails cut it out and weld in.

As in weld the tip of the hammer to the sill? I've seen some pictures of using rivits and attaching slide hammer with vice grips to give more of a pull than just using pliers.. Any advice appreicated..

[MudRunnerTD]

As in weld the tip of the hammer to the sill? I've seen some pictures of using rivits and attaching slide hammer with vice grips to give more of a pull than just using pliers.. Any advice appreicated..

Yeah so if you have a welder then just tack weld the end of the slide hammer to the sill or if you need to give it a lot of big hits then maybe weld something to the sill and a number of spots (chain links or something) that is suitable to hook the slide hammer to and get into it. When you finished your cutting the welds off rather than trying to bog holes drilled.

[happygu]

As in weld the tip of the hammer to the sill? I've seen some pictures of using rivits and attaching slide hammer with vice grips to give more of a pull than just using pliers.. Any advice appreicated..

Skid,

If you can beg or borrow a panel beaters slide hammer, you need to remove the paint with a wire wheel, then spot weld the blind rivet ends in all the areas where you need to pull the panel, then attached the slide hammer to the rivets, and start pulling the panel in small sections at a time.

When you are happy that you have the panel as close as possible to original, twist off the rivets, and start bogging away

Without the right tools it is all about improvising

Mic

[SKID]

As in weld the tip of the hammer to the sill? I've seen some pictures of using rivits and attaching slide hammer with vice grips to give more of a pull than just using pliers.. Any advice appreicated..

I dont want to stuff my slide hammer up for future use, what if I were to weld nuts to the sill and screw the hammer into them to do the pulling, then just break the nuts off when finished?