Bloodyaussie's GQ

[Bloodyaussie]

When you did the 1/4 chop did you have to weld a plate in place? Or how did you seal it?

Here ya go mate.......

http://www.ebay.com.au/itm/Nissan-Pa...afe4cec&_uhb=1

[kind]

Here ya go mate.......

http://www.ebay.com.au/itm/Nissan-Pa...afe4cec&_uhb=1

Thanks mate now all I need is someone with skill to do it for me :P

[Bloodyaussie]

Got rained out today so got home and did a bit more bar work.... did not take a pic but the lower bar now bends up straight after coming off the step.

[taslucas]

mate, i dont mean to be picky but that clamp is gonna get hooked up on heaps of sh!t out on the tracks. Maybe get a smaller one or cut that one down?

and the blue clamp seriously reduces your departure angle....

[liftlid]

mate, i dont mean to be picky but that clamp is gonna get hooked up on heaps of sh!t out on the tracks. Maybe get a smaller one or cut that one down?

and the blue clamp seriously reduces your departure angle....

If you paint it black nobody will know!

[taslucas]

If you paint it black nobody will know!

I didnt think of that!

[Bloodyaussie]

I didnt think of that!

Either did I........ You bone heads!!!!!!!!

I am enjoying doing this just wish I had more time so I could finish it sooner.

I have one issue and not sure how to tackle it and that is the main step in the middle has a bend in it the length along the bottom where the inch and a half pipe is running along.

My plan was top join this the whole length but it will not bend??? what should I do?? I will take a pic tomorrow of what I mean..

[taslucas]

My plan was top join this the whole length but it will not bend??? what should I do?? I will take a pic tomorrow of what I mean..

More clamps

[liftlid]

More clamps

Painted black?

[taslucas]

Painted black?

we should start a custom shop!