To fit all the switches up i removed the blank on the passenger side where the hand brake would go on a left hand drive vehicle.. you know that stupid pen holder thingy???? what were they thinking??

I then bought some plastic and made a switch panel for that spot. I ran a large power cable from the second battery fused at the battery to the new fuse box and split it across the box then branched to each of the new switches from there. I had to put a couple of relays in there to for the Intercooler pump and the intercooler fans which are switched independently.

I sourced over 18 months online a collection of ARB air solenoids and ARB diff lock switches that i scrapped tech print off and am going to re-label for the new needs. You will se in the pics that i am using Duct tape during the build to keep track but rest assured that the labeler will be in full swing at the end.







It started getting pretty busy but this is not the half of it.....







Getting busy now... Not nearly as scary as it looks though







During the wiring up



Excuse the labels