Build of Australia's FASTEST PATROL ...Potentially, Using RB26DETT Goodness :)

[Clunk]

Your gonna need a wider drive way hahaha

Looks good mate

[MudSlut]

Lol yeah well of only just fits out the end of the driveway. Makes it a bit tricky at night with dark as fark tint.

[Ben-e-boy]

if you going to run those rims alot my advice is pre-load the fork out of your wheelbearings and swivel hub bearings or the wobbles will be a constant companion.

[MudSlut]

Thanks, I had noticed a slight wobble under braking and turning, I thought I must have had a slightly warped rotor. Have you seen an article on how to do what you just said?

[Ben-e-boy]

Thanks, I had noticed a slight wobble under braking and turning, I thought I must have had a slightly warped rotor. Have you seen an article on how to do what you just said?

take the shim plates out of the swivel hub bearings, thats about all you can do with them their life expectance is reduced and tighten your wheel bearings. I tighten them until I get 1 revolution with the bigger tyres spinning it off the ground and thats with putting some effort into spinning it.

[MudSlut]

Ok thanks, it sounds like a job for my mechanic.

[MudSlut]

Nothing to worry about anymore guys... The build is over, the patrols are gone, a forged 180sx is in its place. tad sad but I think it's for the best. Too much going on in my life at the moment for modifying a 4wd. Will prob pick it up again in a year or so.

[taslucas]

Oh really!?.
I thought you'd decided to keep it after the last run of mods.
Did you sell it locally? I think I may have seen it up Mt hicks way.

Tap, crackle, pop

[MudSlut]

Yeah I sold it to a guy in wynyard. I would have loved to keep it, but it had to go. ImageUploadedByTapatalk1355380767.591161.jpg
This is what I have now, 2L of forged goodness. Very tail happy

[taslucas]

Oh well, nice knowing you......

Lmao just kidding

Tap, crackle, pop