Looks like you have a flat surface around the bolts, the support for my bull bar is an L shaped bracket with the rear of this preventing the mounting of the recovery point.
Looks like you have a flat surface around the bolts, the support for my bull bar is an L shaped bracket with the rear of this preventing the mounting of the recovery point.
On the alternate point, i think the radiator guard is mounted in that position so no clearance.
Try those Tee shaped ones on the outside of the chassis, see if any holes line up
What year is yours again please
Last edited by threedogs; 3rd December 2012 at 04:24 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Weird but looks like the series one plate will fit. It replaces that loop held on by 3 bolts, you'll just have 3 holes on the LHS with no nuts, Sure that wont fit to outside of chassis
Last edited by threedogs; 3rd December 2012 at 04:41 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Im not sure i understand...
ImageUploadedByTapatalk1354515167.759985.jpg
Does this pic help?
GU IV 2006 4.2 TDi wagon
threedogs (5th December 2012)
Thanks Rip, I also have a limited number of rear seat cover plates to suit the GU. They just tidy up the back a bit after you remove the seats.
Last edited by threedogs; 5th December 2012 at 04:36 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Thanks Rip, Looks like the bull bar mounts are quiet different to what i have. Im working on a solution though.
You'll eventually get it , I can fit all 3 different styles to my TJM bar, go figure
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Posting Permissions
Reply With Quote