Should be able to see where im going now, after the marathon effort wiring these puppies I don't envy auto electricians.
Some pictures of my recently installed lights
Should be able to see where im going now, after the marathon effort wiring these puppies I don't envy auto electricians.
boots (4th November 2012), NissanGQ4.2 (11th October 2012), snewin (4th November 2012)
Light bar and work leds look like they were made to fit there, great job, gotta love LED till the next best thing comes along. can see it being awhile.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Nice setup there mate! I just wired spotties up to mine but I enjoy electrics. Do want the rear lights like yours though!
DIAL-A-TAP
Looks great. I am about to get around to doing rear lights a bit like yours and I have the same roof rack. Any hints on how you ran the cable in to the cab? Cheers.
Yea mate, I looked at this for a while, as I didnt want to drill holes in my roof, I drilled a hole through my roof rack bracket on the passenger side and ran the wire down into the channel along the edge of the roof, The wire then travels to the front of the cab and down behind the snorkel and into the engine bay between the wheel gaurd panel and the windscreen panel (it is a pretty tight fit, took me ages to get the wires through this small gap) I used a bit of silicon to hold the wire in the channel along the roof, and small cable ties down the side of the windscreen (as the previous owner had drilled holes in this part of the channel for a sun visor. Once in the engine bay just to a relay, then switching wires into the cab through the big grommet on the passenger side to a three way switch, one side is power from the battery, one side is the reversing wire, and middle is off.
For anybody interested I picked up the reversing wire from the wiring loom behind the pannel on the left side of the passengers leg, it is the yellow wire among that loom, I think this is pretty standard in most vehicles ( yellow wire = reverse)
I will try and put up some pictures of wiring tomorrow if you would like
Last edited by Boofa; 13th October 2012 at 09:24 PM.
Thanks Boofa sounds like that may be the way to go. Cheers.
Boof, is that an ARB rack, and what light bar did you use as I want that on the rear as a reverse.
Sent from the secret chambers of our secret society, on a secret iPhone, with a secret pin code and eye retina scanning from a secret peep hole, just don't tell anyone OK, cos it's secret........
2011 GU8 ST 3.0 CRD, ARB Bullbar with IPF spotties, scrub bars and side steps, Snorkel, Dual Battery system, Waeco fridge, Turbo Timer, ARB Roof Rack with 5 IPF spotties across the front, Custom full Leather Bucket seats, DPchip, 3" Taipan exhaust, ARE Intercooler & scoop, Autron EGT/Boost and dual volt gauges, ARB front locker.
Yea it is an ARB roof rack, the Led lightbar is a BLB40 22" (40 led's) from Brite Tech Auto in melbourne, The rear ones are BLB4 (4 led's).
The Spot lights are IPF 900XS with HID conversions
You light up my life, very nice Boofa very nice, cheers for the heads up on the reverse wire. Look forward to the pics, Thanks mate
Cheers Pete
Tappn the App with Beer on Tap
"Tonka Tuff" 08-GU6, 3.0lt crd, 5 Speed, Turbo Diesel, Hpd, Arb, Ome, MT Baja Atz.
Cheers Boofa thanks.Originally Posted by Boofa
Sent from the secret chambers of our secret society, on a secret iPhone, with a secret pin code and eye retina scanning from a secret peep hole, just don't tell anyone OK, cos it's secret........
2011 GU8 ST 3.0 CRD, ARB Bullbar with IPF spotties, scrub bars and side steps, Snorkel, Dual Battery system, Waeco fridge, Turbo Timer, ARB Roof Rack with 5 IPF spotties across the front, Custom full Leather Bucket seats, DPchip, 3" Taipan exhaust, ARE Intercooler & scoop, Autron EGT/Boost and dual volt gauges, ARB front locker.
Posting Permissions
Reply With Quote