Hey guys turning my rock sliders into an Air tank hopefully will have a decent capacity on the too being 65mm tube.

What is required for this to happen, I have a thumper air compressor 160/L p/min which will be hard wired in then I will run a line from this to a 'T' piece under the cab where it will divert into each slider.

What is required to get the compressor to cut off at a certain Psi and what Psi would you recommend? I assume I need a pressure switch and if so where in the system does it fit in/how is it wired in? If there is anything else you suggest I do please let me know