Decided it was time to make a snorkel for the Trol. I just don't like any of these massahoosive external ones that go ALL the way down the wing plus they're stupidly expensive:/
So how hard can it be ?
Bought some 3" silicone hose off fleabay in sexy black 2m long £38
Then set about cutting up the air filter housing as follows:


This will be the new way in ish

So next job, drill a dirty great 85mm hole in the bulkhead where these holes are

Here you go, and then file off the edges nice n smooth

To make a nice collar through the bulkhead I found this in me garage It's a 4" soil pipe adaptor for a 1 1/2" waste pipe, ideal

Here it is in place ready to drill the b/h so I can bond it in place

I drilled a big hole in this too so the air intake will fit through it a bit like this

So as that worked so well I bonded it in place with Tiger seal and a few screws to hold it in place till the goo cured. That'll be totally water proof in an hour or so

Next steps will follow in post 2 as there appears to be an image limit per post :/
Back in a bit lol