Winnie's Warn hi mount rebuild

[Winnie]

It was $24.95 mate. That's nt what I need anyways. You don't need them either AB, you just need a couple of longer bolts.

I need 1 or 2 of the square nuts used to hold the top hat on. Hey Winnie you haven't got any in that box of your have you?

Hmm, I'm not sure Daz, I'll check in the morning and if I do then I'll bring them up to Licola for you

[AB]

It was $24.95 mate. That's nt what I need anyways. You don't need them either AB, you just need a couple of longer bolts. I need 1 or 2 of the square nuts used to hold the top hat on. Hey Winnie you haven't got any in that box of your have you?

I know mate but they say RRP $45.

[MudRunnerTD]

I know mate but they say RRP $45.

Oh it's for a Himount winch..... We can charge Drug Money!!!

[Winnie]

Only $2.50 more than low mount.

[nissannewby]

Umm go to the bolt shop? Any decent bolt shop should carry these.

[MudRunnerTD]

Umm go to the bolt shop? Any decent bolt shop should carry these.

Even the square nuts Matt?

[Winnie]

You can fit your filler to the side if you like. Plenty of room. You would have to use a syringe to fill it though? Do it to the front quarter of the casing. Alternatively you could drill and tap big enough for a filler on the side then instead of a plug bolt use a male/female reducer and fit a pnuematic fitting and your breather in the same hole.

So do you mean that when you unscrew your breather then that becomes your fill hole?

[MudRunnerTD]

So do you mean that when you unscrew your breather then that becomes your fill hole?

Yes mate. But the air line fitting I used for my breather is too small so fitting that fitting into a reducer so it can thread into a bigger hole would work fine mate.

So say you have a 1/2" hole tapped" fit a 1/2" to 1/4" reducing socket then fit a 1/4" air line. When you want to fill it just take out the 1/2" socket

[Winnie]

Yes mate. But the air line fitting I used for my breather is too small so fitting that fitting into a reducer so it can thread into a bigger hole would work fine mate.

So say you have a 1/2" hole tapped" fit a 1/2" to 1/4" reducing socket then fit a 1/4" air line. When you want to fill it just take out the 1/2" socket

Yeah cool, thanks I might play around with something

[nissannewby]

Even the square nuts Matt?

Yeah the square nuts they should. Is there something special about the bolts?