GME Programming Lead Diagram

[sarge1950au]

This is to suit the following models.....

TX3200
TX3220
TX3400
TX3420
TX3600
TX3620
TX3800
TX3820
TX4400
TX4600
TX4800

Have a heap of GME programming software, just ask, and if I have what you need, it's yours.

[NissanGQ4.2]

Top stuff, did you use 2 be a dealer? thought the software was hard to get

[sarge1950au]

Mate, I had a business designing electronic radio controlled target systems for Police and Security firearms training, and had mates in the radio game who gave me software for most of the GME's on the market!! I used to do lots of programming for people on a radio techies forum.....

[patch697]

Thats just great Sarge, what an asset to the forum this will be.

Thank you very much indeed.

Feel free to throw up a post in our vendors section for your business if you like to mate.

http://www.nissanpatrol.com.au/forum...-Vendor-Thread

Cheers
Paul

[gbatt64]

Hi Sarge , great to see that there is at least one more Radio Tech out there , been playing with radios & electronics for 34 years (opps showing my age)

Cheers Graeme

[Finly Owner]

Hi Sarge , great to see that there is at least one more Radio Tech out there , been playing with radios & electronics for 34 years (opps showing my age)

Cheers Graeme

Graeme have you always been down south? never lived up this way?

[dronus]

i bought the radioworks programming lead for the GME tx3820 and have a copy of the programming software but everytime i try to connect to it i get a message saying that it cannot connect to the radio, and i should check my com port and lead. I have tried it on winXP and win7, both using a USB-serial adapter and straight to a serial port.

I have it set to com 1 (which is correct), and default speed etc.

Funny thing is, it connects fine to a tx3800.. Any ideas or someone in adelaide who might like to have a look?

[Woof]

Hey Dronus, it's always a good idea to post up an introduction before asking questions mate, just gets everyone on side immediately.

[NissanGQ4.2]

i bought the radioworks programming lead for the GME tx3820 and have a copy of the programming software but everytime i try to connect to it i get a message saying that it cannot connect to the radio, and i should check my com port and lead. I have tried it on winXP and win7, both using a USB-serial adapter and straight to a serial port.

I have it set to com 1 (which is correct), and default speed etc.

Funny thing is, it connects fine to a tx3800.. Any ideas or someone in adelaide who might like to have a look?

Hi there, welcome 2 the forum mate, my suggestions is to 1st.....post up an intro as more members will respond if you have done an intro. 2nd start a new thread with your question, as u might get more of a response. I have a TX3400 and have no drama's connecting, don't think i have tried it in win7 but can't see it been a problem if i ran it in XP mode. Will run it on the weekend 2 see if it connects on win7 without XP mode.

Cheers

Todd

[andistahl]

mate,
may I ask you for the software for the TX3220 ?
I searched high and low and just cant find anything on the net.
And if you dont mind, a higher detailed diagram which allows to read the details of the components would be great as well :-)
Thanks heaps in advance
andistahl