-
5th March 2024, 09:48 PM
#1
Beginner
Exhaust help !
Hi All
Recently installed a 3inch turbo back exhaust (with cat & hotdog) in my ZD30CR sounds great runs terrible
Feels like I've taken a step backwards, less responsive , even bigger turbo lag.
Been told its actually running in limp mode, but no engine light is on, is this possible ?
Also been advised a Tillix boost control kit will fix the issue ?
Appreciate all the help i can get, I'm a noob when it comes to this stuff...
Thanks all
Sent from my iPhone using Tapatalk
-
-
5th March 2024 09:48 PM
# ADS
Circuit advertisement
-
6th March 2024, 07:42 AM
#2
Patrol Guru
I had the same. You will have to go with a dawes valve set up or risk over boosting your engine.
Be the person that your dog thinks you are!!
-
The Following User Says Thank You to Coldcomfort For This Useful Post:
mannyr.2000 (6th March 2024)
-
6th March 2024, 12:28 PM
#3
The master farter
Yep. You need to add some manual boost control in now to fix all this.
-
The Following User Says Thank You to mudski For This Useful Post:
mannyr.2000 (6th March 2024)
-
7th March 2024, 02:05 PM
#4
Expert
It can run like crap without an error code, I've done it when I forgot to tighten an intake clamp.
there are two blanking plates available. you can blank at both ends to reduce intake/exhaust turbulence. The intake side goes under the EGR volume control valve (if you're wondering)
There are various manual boost control options, I have the HPD type only with no needle valve. I have a bung tapped into the steel intake pipe above the turbo for boost reference.
You have to do both at the same time, blank EGR and manual boost control and as I recently learned keep the vacuum solenoid connected to the wiring harness otherwise it WILL go into limp mode.
Last edited by pollenface; 8th March 2024 at 04:57 PM.
2008 CRD Auto Wagon
-
The Following User Says Thank You to pollenface For This Useful Post:
mannyr.2000 (8th March 2024)