I know the crank is already stuffed but that would lock the seal on. I did think of getting a plate machined with an off centre hole, so that when it was pushed into the groove, the outer circumference was concentric to the shaft.
I know the crank is already stuffed but that would lock the seal on. I did think of getting a plate machined with an off centre hole, so that when it was pushed into the groove, the outer circumference was concentric to the shaft.
Last edited by mudnut; 16th November 2017 at 05:46 PM.
My advice is: not to follow my advice.
Posting Permissions
Reply With Quote