What Nissan four cylinder "petrol" engines will bolt up to a Cabstar/Patrol gearbox with standard Nissan parts or bell housing?
Any of the "L" series engines?
Is there a bell housing that will allow a Z24 2.4 litre engine to bolt up to this gearbox?
Cheers, Mick.
Last edited by Mick88; 2nd September 2015 at 09:08 PM.
According to my Cabstar manual the 3 petrol motors fitted were the Z16, Z20 & Z22.
2006 4.2TDi ex-Telstra Remote area Camper. Patrol Sold after 11 years of ownership Replaced with 2006 OKA NT Expedition Truck. Cummins, Allison & lots of goodies
A Nomadic Life (Blog)
Nice introduction mate............slip over here http://www.nissanpatrol.com.au/forum...-Introductions and post up an introduction, it is something we like all new members to do before asking for assistance so we can welcome you, that way everyone gets a nice warm fuzzy feeling
If any members require assistance in anything regarding this forum, just let me know via a PM and I will help you in any way that I can.
Than you Cuppa,
Would you know if the Z24 has the same bolt pattern as the other Z's you mentioned?
Cheers, Mick.
No idea Mick. Following Tuppa’s advice might see you get further info.
2006 4.2TDi ex-Telstra Remote area Camper. Patrol Sold after 11 years of ownership Replaced with 2006 OKA NT Expedition Truck. Cummins, Allison & lots of goodies
A Nomadic Life (Blog)
Late reply.
Im sure I read some were that they are basically the same box as the mq range. Possibly lower 1st gear
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
Posting Permissions
Reply With Quote