Where exactly is the 3/8 hose?
Where exactly is the 3/8 hose?
My advice is: not to follow my advice.
Hose.png
Did that work?
Anyway, that's the fuel hose I've jammed on to for now (not that it does much at the moment, most of my brand new coolant is all over the ground), it goes from below the bleed screw to the intake manifold.
Maybe just a short term solution.
My advice is: not to follow my advice.
On what grounds?Maybe just a short term solution.
Getting the "correct" hose is no drama. I am just curious what the difference is, I can't seem to find a straight answer.
I've heard of fuel turning the incorrect hoses tacky, which I guess is fair enough. Is there a reason I can't use any given hose for coolant?
It says 10 bar on it, so I guess it has some kind of pressure rating.
I would think that coolant and fuel act differently to the types of rubber that are used. I used to smear any grease I had on the connections of the water hoses, until it was pointed out to me, that grease is a hydrocarbon and will make the coolant hose rubber deteriorate. I now use a food grade grease on all of the coolant system joints. The coolant will be at around 100 degrees, so that may cause the fuel hose to harden, maybe.
Last edited by mudnut; 21st December 2015 at 06:47 PM.
My advice is: not to follow my advice.
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
for coolant hoses the best grease i've used is lube, its water based so no damage to coolant hoses.
if its worth doin its worth over doin
Last edited by dom14; 22nd December 2015 at 08:50 AM.
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
the adult shop......
if its worth doin its worth over doin
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach