Parksy's gq

[garett]

yeah i'm getting ontop of mine too, new shocks made a big difference old ones were 15 or more years, dynamat has made the td42 alot quieter when the windows are up. i havn't changed my window winders yet but i'm trying to get it on the road for now just organising a swing away wheel carrier then rego is next.

[Parksy]

Andrew you need to come and sort the 5 million rattles my car makes.... I do not hear them until someone else gets in my car and says " Doesn't that noise annoy you " then I go nuts as all I hear is that f$#king noise from then on !!!!!

I'll take you for a spin one day Jonathan. I've made this thing suitable for everyday driving, and I think I've finally succeeded. No more yelling at annoying noises from me...

[Parksy]

After fitting the general grabber at2's one thing became apparent, they are larger and do suck a bit more fuel to get moving, so attempting a few things on the injected tb42 to help its cause.
Pulled the extractors off to find that the ports are poorly matched.

Thanks to the carbon build up, I had a template to remove some material and prevent this area of slight blockage.
The extractors came with the oxygen sensor mounted on the cylinder 1, 2 and 3 tubes only, so I welded a bung onto the bottom so the oxygen sensor can get a proper reading of what the engine is doing. Ignore the bad welding...

Am also in the process of wrapping the exhaust in heat shield tape as well to assist in lowering under bonnet temps and increasing extractor efficiency.
Have read the pros and cons of the heat tape, so this is trial and error and will find out for myself what the outcome is.

[Winnie]

I won't ignore that bad welding. Bloody hell, dodgey car!

[Parksy]

Hahahaha everyone watch out, parksy is on the road again...

[Roess]

After fitting the general grabber at2's one thing became apparent, they are larger and do suck a bit more fuel to get moving, so attempting a few things on the injected tb42 to help its cause.
Pulled the extractors off to find that the ports are poorly matched.

Thanks to the carbon build up, I had a template to remove some material and prevent this area of slight blockage.
The extractors came with the oxygen sensor mounted on the cylinder 1, 2 and 3 tubes only, so I welded a bung onto the bottom so the oxygen sensor can get a proper reading of what the engine is doing. Ignore the bad welding...

Am also in the process of wrapping the exhaust in heat shield tape as well to assist in lowering under bonnet temps and increasing extractor efficiency.
Have read the pros and cons of the heat tape, so this is trial and error and will find out for myself what the outcome is.

Must say after reading the entire thread. The way you use the socks in that type of sandals really was the coolest

[Parksy]

Ahh crap, I actually realised when I took the photos that my feet were showing, so I purposley took new photos without my feet in them. But a couple of beers later and I totally forgot about uploading the correct pics. Too funny...

[Clunk]

Must say after reading the entire thread. The way you use the socks in that type of sandals really was the coolest

Well it is winter here after all

[Roess]

haha, really made my day Parksy well up here we have summer but we need shoes instead of sandals anyway :P

[Parksy]

Happy to hear Roesen.
Here is the exhaust all wrapped up.

Re-installed into the patrol

When starting the patrol after wrapping the headers.