Hey guys,
Can I clean the diff centre unit(spider gear, clutch plate assembly) with degreaser and flush out any gunk?
Hey guys,
Can I clean the diff centre unit(spider gear, clutch plate assembly) with degreaser and flush out any gunk?
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
Few more photos.
Soon after dismantling and cleaning the diff centre assembly off the diff centre housing.
It only took couple of not so hard hits with a rubber mallet(on the top rod end of the pinion gear) to get the pinion gear off the
pinion bearing.
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
These are some closeup pictures of the parts of the pinion gear, pinion bearings and races.
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
These three pictures show the carrier bearing preload adjusting shims & their locking retainer mechanism.
These pictures were taken before I removed the pinion gear off the diff centre housing. This is a late post of these pictures.
RB30, some 2-3 inch lift auxiliary LPG tanks
Few more mods on the way
http://www.worldwildlife.org/species/tiger
https://www.panthera.org/
Cheetah Outreach
Danyael (21st January 2020)
I've just went through it and this is a fairly good documentation of a dissection;-) In my opinion those bearings were no good. How did You end up with this project? Did You fix it or have You changed the whole thing?
Sorry, mate. Dom has been gone for a very long time, so don't expect an answer.
rusty_nail (21st January 2020)
Posting Permissions
Reply With Quote