Hi here are the drawes I made did not think to take any shots till after I started work fine :)
Printable View
Hi here are the drawes I made did not think to take any shots till after I started work fine :)
Very neat and tidy job mate!!Quote:
Originally Posted by stevsr31
Very impressive mate!
Ten times better then my timber ones...LMAO
x2 very niceQuote:
Originally Posted by Bigrig
them there are some pretty saucy looking drawers mate
Very good job mate well done
not three bad at all ............where`s mine?????
Nice work Steve. I wish I could work metal like you obviously can. If I had made mine out of metal, even with a MIG they would look like swiss cheese.
My timber ones are not that neat now, though I was pretty proud of them when I first made them. I used the sliding shelves from a computer rack, which have pretty good ball bearing runners.
The most expensive part was the marine ply and they are a bit heavy, but cheaper than ARB etc. Pity I made them a bit higher than I would like but they hold lots of s**t.
how did you make the fridge slider part
very nice good job
Love it, do you have all your slides on bearing and no commercial sliders in them. Did you make the sliders from steel or aluminum?
Nice job did you shape the metal yourself or did you buy it like that?
looking good mate, might need something like that for my truck!