I've called it i won't be doing it. I got no means , time or premises to do it so to workshop it goes.
Sent from my SM-G920I using Tapatalk
Printable View
I've called it i won't be doing it. I got no means , time or premises to do it so to workshop it goes.
Sent from my SM-G920I using Tapatalk
I chickened out of cutting mine too, only cost a slab of crownies to the panelbeater. He said don't use a grinder, and used an air hacksaw.
Less sparks, less finish work.Quote:
Originally Posted by Winnie
Either a hacksaw or piston nibblers (drill powered ones) work well and leave a nice clean edge..
Just make sure you use em on a clean flat surface.. the shavings are half moon shaped spikes from hell!!!!
I took mine to a panel beaters and they cut the hole, welded a piece into the bonnet, painted the bonnet and scoop and fixed some holes and resprayed my left hand guard for $900 cash
I used an air hacksaw for mine, worked a treat .... Twice. :redface:
@mudski @Rocket55
How are your fans for the inter cooler wired up? There is not a single bit of info or instructions on how it's meant to be setup.
There is a blue wire in the loom I believe, so is it intended to be constant on with IGN ?
For some reason I believed/though the fan was thermally kicked in. My bad.
Dont fit it....
There's ignition power in the wiper motor. Thats the easiest spot to get power.
The blue wire would go here.
Sent from my SM-P600 using Tapatalk
Yeah that's where I already got ign from for my Redarc. So I'm guessing it is meant to be like that always on when ign on ?Quote:
Originally Posted by mudski
Not a fan of a fan Mat ?Quote:
Originally Posted by nissannewby