Bent up Sill

Quote:

---

Originally Posted by SKID

I dont want to stuff my slide hammer up for future use, what if I were to weld nuts to the sill and screw the hammer into them to do the pulling, then just break the nuts off when finished?

---

It would work - as it is all about improvising, but you would have a fair bit of grinding/cleaning up to do with this method.

Mic

This should make you feel better

Passenger side all todays efforts :D

Attachment 43524

Drivers side some old some new :D
Attachment 43525

Quote:

---

Originally Posted by Ben-e-boy

This should make you feel better Passenger side all todays efforts :D <img src="http://www.nissanpatrol.com.au/forums/attachment.php?attachmentid=43524"/> Drivers side some old some new :D <img src="http://www.nissanpatrol.com.au/forums/attachment.php?attachmentid=43525"/>

---

Thats factory isn't it Bene??

Don't tell me the CV is finally fixed !!!

Quote:

---

Originally Posted by 04OFF

Don't tell me the CV is finally fixed !!!

---

Yeah I fixed that about a month ago. :p

Quote:

---

Originally Posted by happygu

It would work - as it is all about improvising, but you would have a fair bit of grinding/cleaning up to do with this method.

Mic

---

Spent yesterday pulling the dent down and out, now I've pulled it too far, am thinking about cutting a window in the sill cutting out the worst bit and use dollies etc to straighten things up then close the window by welding a plate over it, will cut a section from an old door I have, then bog the inperfections. But my mate says thats too hard work and recons to bash in what I pulled out too far, but can figure how he expects to get a flat straight edge with out having a dolly of some discription on the inside of the sill to hit against...

Quote:

---

Originally Posted by Ben-e-boy

This should make you feel better

Passenger side all todays efforts :D

Attachment 43524

Drivers side some old some new :D
Attachment 43525

---

I would have been happy if that is all that was done to my sill, ming bent up to the point that the side of the sill was flat under the door.. As per the pic's I posted

Someone fix mine haha

Quote:

---

Originally Posted by SKID

Spent yesterday pulling the dent down and out, now I've pulled it too far, am thinking about cutting a window in the sill cutting out the worst bit and use dollies etc to straighten things up then close the window by welding a plate over it, will cut a section from an old door I have, then bog the inperfections. But my mate says thats too hard work and recons to bash in what I pulled out too far, but can figure how he expects to get a flat straight edge with out having a dolly of some discription on the inside of the sill to hit against...

---

Just tap it back in if you have pulled it too far.

If you have stretched it too much, once you have tapped it back, you can try shrinking it a little with an Oxy Set

Mic

Quote:

---

Originally Posted by Ben-e-boy

This should make you feel better

Passenger side all todays efforts :D

Attachment 43524

Drivers side some old some new :D
Attachment 43525

---

Well done Ben,

You only have short sills to aim at ....:p