7th January 2014, 07:55 PM
the year model of your gu is in the main grenade era . I think you should do the full nads program on your motor . I have a later model with few Ks so I have only done the catch can at present ....
7th January 2014, 06:51 PM
sorry mate i have a 4.2 not much of an idea with 3ltr
10th August 2013, 06:35 PM
I used that in my old Commoder that did a hell of a lot of heavy towing and changed it once every 2 yrs. At one stage the lsd started to chatter in reverse so I did an early change. Diff was still...
9th August 2013, 09:06 PM
Not sure of the oils, but some guys add some engine flush. The stuff you add to the engine oil to clear it out.. You need roughly 1000k in the diff they reckon.
31st January 2013, 07:43 PM
[QUOTE=rusty_nail;325946]we normally go in at about the first entrance after the tip, then head out to the mud flats then go rock climbing on a track that leads out near Lucas Heights HS. it took...
30th January 2013, 04:06 PM
stopped by the nissan deelership in bundanba this morning to enquire on a couple of biot n pieces for my Y61.
whilst there i had noticed they have reintorduced the nissan pulsar to replace the...
22nd January 2013, 06:23 AM
Was going to say there should be a common thing between all of the negatives, and that's the trace.
So all the wires with a trace are negative.
Kallen Westbrook
Owner of
Westy's Accessories
22nd January 2013, 04:59 AM
Easiest way to check this is a 2 person job, Get a AA battery and tap the wires on the battery, the 2nd person watches the cone, it will either move up or down, If it moves up the polarity is right,...
14th January 2013, 03:48 PM
I use the moly grease for the hubs aswell or any high pressure high temp will do
11th January 2013, 08:19 PM
2012 gu8 common rail st. As mentioned above.. Yes with air con on and rear air con running as well. There is no fans in front of the radiator or air con radiator..
3rd January 2013, 09:58 PM
The penright 140 is good I have also been told Castrol make a good lsd oil
18th September 2012, 09:27 PM
Morton,
I haven't looked carefully at the GlowPlug Rail, but speaking from experience, it is always a poor connection that causes corrosion at a joint.
It is unlikely that the leaking...