-
19th April 2016, 08:54 PM
#1
TB42 vs TB45 drive shafts interchangeable?
I have a TB45 GU that needs the rear driveshaft universal joints replaced. A mate happens to have a rear driveshaft from a TB42 GQ, I figured I could fit the replacement driveshaft while I replace the universal joints on my driveshaft - that way my car isn't off the road so I can take my time.
So the questions is, are the two driveshafts interchangeable?
WARNING: Using a Tow Ball on any Snatch can KILL PEOPLE!
-
-
19th April 2016 08:54 PM
# ADS
Circuit advertisement
-
21st April 2016, 12:44 PM
#2
WARNING: Using a Tow Ball on any Snatch can KILL PEOPLE!
-
The Following User Says Thank You to JME_GU For This Useful Post:
Skitzyrex (25th April 2016)
-
21st April 2016, 04:12 PM
#3
Patrol God
I'd say yes as the are virtually the same block, gear box and diff setup..
Pretty sure the only different drive shaft was the 2.8 and that had smaller flange plates
-
-
25th April 2016, 08:01 PM
#4
Originally Posted by
biggqwesty
I'd say yes as the are virtually the same block, gear box and diff setup..
Pretty sure the only different drive shaft was the 2.8 and that had smaller flange plates
Cool, thanks for the reply
WARNING: Using a Tow Ball on any Snatch can KILL PEOPLE!
-
The Following User Says Thank You to JME_GU For This Useful Post:
BigRAWesty (25th April 2016)