-
17th March 2013, 03:58 PM
#1
Fitting 2 inch lift
Am thinking of making the purchase......finally..... Of a 2 inch lift for the troll. Is it something I would be able to fit myself or should i take it to get installed. Also if I fit it myself is there anything I should look at upgrading replacing at the same time. As far as I know for 2 inches all I really need is the springs and shocks no need for break lines etc.
Cheers.
Twiggsy
-
-
17th March 2013 03:58 PM
# ADS
Circuit advertisement
-
17th March 2013, 05:10 PM
#2
Legendary
Fitting 2 inch lift
Should be all good when you do it drop the sway bar links off and the the shocks and you'll be able to pull the old springs out and drop the new ones in without spring compressors. Don't forget to adjust your steering wheel when finished
Just tap it in just tappy tappy tappy
-
The Following User Says Thank You to 93patrol For This Useful Post:
twiggsy (17th March 2013)
-
17th March 2013, 05:15 PM
#3
Advanced
Fitting 2 inch lift
It's very easy. Did mine a few months ago - should take about 20mins a wheel.
I also used a bottle jack to push the front diff down from the chassis. The springs fell out.
Make sure you disconnect the sway bar.
-
The Following 2 Users Say Thank You to Dam355 For This Useful Post:
Biscuits (22nd March 2013), twiggsy (17th March 2013)
-
17th March 2013, 06:30 PM
#4
If using the bottle jack just make sure you get it square on. I helped a mate do his VX cruiser a couple of years back this way and we had awe woops and the jack came flying out at a million miles an hour and broke his arm, so do be careful.
Also just keep an eye on your brake lines when you drop the diffs down. It also pays to extend the mounting for the front brske lines where they attach to the diff which is real easy to do with a bit of tin or SS
-
-
17th March 2013, 06:35 PM
#5
also you can get swaybar correction brackets. they fit where your swaybar link connects to your chasis on the rear helps to correct diff position and swaybar angle
-
-
17th March 2013, 07:30 PM
#6
Expert
hi mate, easy job i suggest you buy some new spring saddle rubbers when i did mine they were worn out , and when i did the front i undid the little brake line tee on the diff and the steering damper it made things a little easier,jack up the vehicle place stands under the chassis so the wheels are off the ground and use your jack to support diff, i took the opportunity to rotate the wheels and check the brakes as well plus it made it a bit easier to fit the new springs and shocks, and undo the sway bars too, it me about two hours but i took it steady and had a little trouble with the front top shock nuts, cheers hope it helps a bit
01 gu td4.2t wagon factory turbo 2" lift, 3" exhaust,snorkel,awning,uhf,egt & boost gauges,16"black round hole dynamic rims with 285 bighorns with more to come, ,air compressor,rear led work lights,winch, ready to fit up
-
-
17th March 2013, 07:55 PM
#7
Expert
If ya can get hold of a 4 post hoist it will be quick as.
06 GU IV Nissan Patrol wagon 3.0L, Tough Dog 2" lift, Xrox bar, 12k Mako winch, 33" muddies, 3" exhaust, Awning, UHF, drawers & fridge, custom sliders, DVDs, custom water tank and pump, rack etc etc.
Now just in - GQ Shorty 4.2 petrol, UHF - but looking at turbo or V8 conversion
-
-
17th March 2013, 08:27 PM
#8
Moderator
If you grab the lift kit before Easter you are welcome to drive to Lara and fit it in my driveway. I will be doing a diff swap and will be busy but if you get stuck I will be 10m away.
Really easy job though mate.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
-
17th March 2013, 09:31 PM
#9
Hardcore
Originally Posted by
benno77gu
hi mate, easy job i suggest you buy some new spring saddle rubbers when i did mine they were worn out ,
Good advice, its hard to tell how shagged they are till you get them out, then its too late to order some, made the same mistake myself.
-
-
19th March 2013, 08:03 PM
#10
Thanks all for the advice. Very helpful. Lets see how things go!!!
-