-
6th February 2020, 10:36 AM
#1
Gen S4 Snorkel to an S3
Howdy all,
I have access to a friends genuine S4 Nissan snorkel and would like to put it on my S3 (no snorkel). Both vehicles are TD42Ti`s. Has anyone tried this before or are there major differences in the sizing and guards?
Cheers
-
-
6th February 2020 10:36 AM
# ADS
Circuit advertisement
-
6th February 2020, 12:05 PM
#2
Moderator
The guards are basically identical and it is just the flares that are different. It should go straight on.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
The Following User Says Thank You to MudRunnerTD For This Useful Post:
Pimpmyhubcap (6th February 2020)
-
8th December 2020, 04:40 PM
#3
Just thought I would finish off this post with the outcome. Got a friend who is a panel beater to cut and paint the holes near the airbox and the rear of the panel. I then fitted it myself with a little gap filler on the joints.
130605819_220829812747699_2833887791188427674_n.jpg
130449395_236848024536897_5935135444072457424_n.jpg
-
The Following 3 Users Say Thank You to Pimpmyhubcap For This Useful Post:
Cremulator (8th December 2020), MB (8th December 2020), mudski (11th December 2020)