-
8th October 2019, 09:34 PM
#1
-
-
8th October 2019 09:34 PM
# ADS
Circuit advertisement
-
9th October 2019, 11:54 AM
#2
The master farter
Mark is the sensor two wire or single wire mate? If single it should just be a simple switch, on (at the set temp) and off. So if you heat some water to the set temp, attach a DMM to the thread and then to the wire, if the switch is working it should trigger at the set temp. Should. Lol.
Last edited by mudski; 9th October 2019 at 11:59 AM.
-
The Following User Says Thank You to mudski For This Useful Post:
-
9th October 2019, 12:42 PM
#3
.........
-
-
9th October 2019, 04:15 PM
#4
The master farter
Originally Posted by
MB
Thanks Mark mate, appreciated!
Think it is single wire so I’ll give that a go tonight
@
matfew sparky is in the hills later this evening too so might be able to handball this task to him
Sent from my iPhone using Tapatalk
Yeah should work in theory. It works on the similar principle to an oil pressure switch, but is activated by heat. The switch is just an earth contact for the fan.
-
The Following User Says Thank You to mudski For This Useful Post:
-
11th October 2019, 08:38 AM
#5
The master farter
-
The Following User Says Thank You to mudski For This Useful Post:
-
11th October 2019, 12:51 PM
#6
.........
Haven’t had a crack myself yet mate and poor old Matfew has been flat out like a lizard drinking, 4:00am starts the poor bugger!
Sent from my iPhone using Tapatalk
-
-
11th October 2019, 01:06 PM
#7
The master farter
Originally Posted by
MB
Haven’t had a crack myself yet mate and poor old Matfew has been flat out like a lizard drinking, 4:00am starts the poor bugger!
Sent from my iPhone using Tapatalk
I have to drop off parts to a customer in Yarra Glen in the morning. I can drop past and take a look if you like.
-
The Following User Says Thank You to mudski For This Useful Post:
-
11th October 2019, 01:14 PM
#8
.........
-
-
11th October 2019, 02:02 PM
#9
The master farter
Originally Posted by
MB
That’d be awesome, thanks mate
Sent from my iPhone using Tapatalk
No worries. I'll call you in the morning.
-
The Following User Says Thank You to mudski For This Useful Post:
-
11th October 2019, 07:39 PM
#10
Moderator
Yeah you would test that the same way as a thermostat in a pot. Test to boil.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
The Following User Says Thank You to MudRunnerTD For This Useful Post: