-
27th March 2015, 08:33 AM
#31
Patrol God
I like it and and dont forget the grip tape, and it'll hurt like hell when you slip off them and bang your shin.
The 3mm strap is a good idea a bit less weight than going up to 6mm wall plus the price as well
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
-
-
27th March 2015 08:33 AM
# ADS
Circuit advertisement
-
27th March 2015, 07:10 PM
#32
Expert
Two great ideas.
They're all welded up and looking sweet.
I'm buying the gussets tomorrow, finishing the ends and sourcing some plate for the bottom at some stage.
How thick should the plate be? Is 1.6mm to thin?
Last edited by mjr350; 27th March 2015 at 07:24 PM.
-
-
5th April 2015, 07:31 PM
#33
Expert
Well they're on. Been on for a while but forgot to post.
They fell straight into place even after all the support gussets welded in. I did prepare for a little bit of warping but it was minimal.
Didn't end up plating in the bottom. I was running out of time and steel shops don't open on weekends up here as of last weekend.
100mm x 3mm flat will fit easily so don't have to cut from a sheet if I feel the need one day.
I'll grab some pics when I get a chance.
-
The Following User Says Thank You to mjr350 For This Useful Post:
MudRunnerTD (7th August 2017)
-
7th August 2017, 08:14 PM
#34
If u want 45 bends just cut a 90 in half that's what we do on the job
-
The Following User Says Thank You to Tip12345 For This Useful Post:
MudRunnerTD (7th August 2017)