After looking for a while for some pics that may help with my install, and not finding a lot, I thought I'd take a few for others.
Firstly, before installing, you will need 10x40mm high tensile bolts if using the Hawse Fairlead provided. You will also need to rotate the winch so as the clutch is in the drivers side which means the rope will come off the top side of the winch. This means you will also have to rotate the clutch, of which I used this short video with no problems at all.
http://youtu.be/Nt-VpTs4AUY
Now to the installing, which can be done without removing the bullbar.
I fitted the controller first, just by bashing out the plate in the bar and drilling two 6mm holes. I did have to bend the bracket to a more vertical angle as it was hitting the grille.
ImageUploadedByMotorculture1434867709.325444.jpg
ImageUploadedByMotorculture1434868081.653022.jpg
Then moving to the winch, just remove the bottom bash plate and get something to hold it in place. I just used some blocks of wood, and my small trolley jack.
ImageUploadedByMotorculture1434866840.613853.jpg
You will need to lift it up with the mounting holes facing downwards then rotate it once you have it at the right height otherwise it won't fit.
Before bolting it up, I left the jack holding it in place whilst connecting all the cables as of the small space that there is to work with.
Then just line up the bolts, remembering you'll need the two 40mm bolts and do it up. I initially rotated the clutch 90 degrees which wasn't enough as you couldn't lift and rotate the handle to disengage it.
ImageUploadedByMotorculture1434868544.033241.jpg
I then rotated it one more bolt hole towards the bar which is spot on.
ImageUploadedByMotorculture1434868642.570269.jpg
Then it's just a matter of putting the hook on, bolting up the bash plate and connect to the battery before testing.
Now, if there were two of you, it may be easier just to remove the bar because of the limited space there is to work with. Just remember if you have aerials, spotlights etc, you have to disconnect all of them before doing so.