-
8th September 2014, 06:31 PM
#1
Administrator
Are there differences in ARB deluxe winch bars
G'day Sam or anyone else who may know the answer...
Did the arb deluxe winch bar differ in size at all for the gq patrol?
-
-
8th September 2014 06:31 PM
# ADS
Circuit advertisement
-
8th September 2014, 08:03 PM
#2
Legendary
As far as i remember, there was a DX split rim version, for the GQs with no flares, and the wide wheel pack version, which was the most common, as most ordered the wide wheel pack
GU PATROL 2011 Ti, with goodies...
-
The Following User Says Thank You to happygu For This Useful Post:
-
8th September 2014, 08:27 PM
#3
CERTIFIABLY INSANE
Originally Posted by
AB
G'day Sam or anyone else who may know the answer... Did the arb deluxe winch bar differ in size at all for the gq patrol?
Which dimension AB?
Sent from my iPhone using Forum Runner
1997 GQ Patrol RX, TB42E. Mods: OME 2" lift, 33" BFG KM2'S, ARB winch bar & reconditioned X9 Superwinch, IPF 900 spotties HID conversion, ARB side steps and scrub bars, Kaymar rear step & spare wheel carrier & jerry holder, Rear 55W LED worklight, Safari Snorkel, 147L LRA tank, Extended diff breathers, dual batteries, GME UHF, Home built drawer and fridge slide, ARB 60L fridge.
-
-
8th September 2014, 08:31 PM
#4
Administrator
Originally Posted by
Drewboyaus
Which dimension AB?
Sent from my iPhone using Forum Runner
The only measurement I checked is below.
Rosscos measured I think 230mm from behind front plate to grille.
Mine measured 215mm
Both bars were pushed back to mounts and mounted correctly. In fact both were pushed back to body mount plates so...
Edit....ill have to double check exact measurements of front of chassis etc but that's what I saw in the interim.
-
-
8th September 2014, 08:38 PM
#5
Administrator
Everything's fine, the highmount will fit and I could not of done this without johnos bar but I may need to cut my grille up which is disappointing.
It looks so pretty at the moment... Lol
I'm lucky the ic is mounted up high where the highmount tapers back!!!
-
-
8th September 2014, 08:51 PM
#6
Moderator
They should be the same mate.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
-
8th September 2014, 09:00 PM
#7
CERTIFIABLY INSANE
There was a bar style that would accommodate a high mount or low mount. There was a huge open area in front of the grille.
I do remember my mate (who works for ARB) commenting when I got my deluxe bar that it was a later model......maybe they changed the design a little.
Sent from my iPhone using Forum Runner
1997 GQ Patrol RX, TB42E. Mods: OME 2" lift, 33" BFG KM2'S, ARB winch bar & reconditioned X9 Superwinch, IPF 900 spotties HID conversion, ARB side steps and scrub bars, Kaymar rear step & spare wheel carrier & jerry holder, Rear 55W LED worklight, Safari Snorkel, 147L LRA tank, Extended diff breathers, dual batteries, GME UHF, Home built drawer and fridge slide, ARB 60L fridge.
-
-
8th September 2014, 09:01 PM
#8
Administrator
Originally Posted by
MudRunnerTD
They should be the same mate.
Yep they should be...lol
Ill take proper measurements on the weekend from chassis to a point on the bar but I'm pretty confident in the above mate.
Just not getting a break lately damn it!!!
-
-
8th September 2014, 09:02 PM
#9
Moderator
Originally Posted by
Drewboyaus
There was a bar style that would accommodate a high mount or low mount. There was a huge open area in front of the grille.
I do remember my mate (who works for ARB) commenting when I got my deluxe bar that it was a later model......maybe they changed the design a little.
Sent from my iPhone using Forum Runner
Yes the two bars your talking about are the ARB Commercial bar which takes a Lowmount r Himount and has a very big nose and the ARB Deluxe winch bar specifically designed for a Lowmount winch and has a much shorted nose and better approach angle.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
-
8th September 2014, 09:07 PM
#10
Administrator
Originally Posted by
Drewboyaus
There was a bar style that would accommodate a high mount or low mount. There was a huge open area in front of the grille.
I do remember my mate (who works for ARB) commenting when I got my deluxe bar that it was a later model......maybe they changed the design a little.
Sent from my iPhone using Forum Runner
Rossco was bloody close though, it was 1mm off the grille. He also had to cut a section out of the bottom cross bar to fit it and also had to space it back 3mm from the front plate because of the returns on the bar hitting the winch so he's is definitely not suitable for a highmount straight fit.
Easy fix though for these solid bars, don't get me wrong just confused of the 15mm difference that's all.
I want to 100% confirm this though with some solid structure measurements, not a measurement to the plastic grille so ill double check another day and get back to you.
-