Welcome to the Nissan Patrol forum. To post a question and to see less adds on the forum then you will have to register
first. We are an easy going friendly forum so join in the conversations and feel free to ask any questions.
Become a forum sponsor for only $20 and see no adds with faster page loading times and many extras benefits.
Last year I reconditioned my auto gearbox (RE4R03A) which I posted about here. All has been going well for 10,000km or so. Been using a manual Torque Converter lock-up mod since christmas with nice results.
However, after my last trip (CSR) I noticed during the limp back home to Perth that the torque converter was occasionally shuddering. It feels like driving over a cattle grid and seems to last a couple of seconds before going away again. This doesn't happen during lock-up itself but some time after and not consistently either. When I got back I dropped the fluid and it looked a bit brown but didn't smell burnt like it was when I rebuilt the box. I suspect the oil is passed its best which is surprising after only 10,000km, but then again, I did just give it a hammering for the last 6,000km, mostly off road. Last year I used OEM oil that I bought from Driveline AP in Perth. This time I refilled with some fully synthetic ATF (Valvoline Max-Life) and ran for a few minutes before repeating to get mostly fresh oil into the box. At the same time I fitted a transmission oil cooler to try and slow down the oxidation of this new batch of fluid.
On driving after warming up the shudder in lock-up came back. Happens occasionally in 2nd, 3rd and 4th and stops as soon as you turn off the manual lock-up. So the problem is still there with a vengeance! So I have a few questions for those that have also had auto woes:
-How long shall I run around with shudder to see if the new fluid makes the shudder go away?
-Can I really have stuffed the torque converter clutch in 10,000km?
-Could it be low line pressure?
-Could it be a knackered line pressure or torque converter lock-up solenoid?
-Could it be the input shaft seal?
-Any other ideas?!?!?