-
13th December 2012, 02:14 PM
#1
Advanced
Need help!!!
Hey guys,
I pulled my Bullbar off to put in a winch and plate.
As I can't fit the Bullbar back on until I get the fair lead bracket grinder off it still remains on the floor of the garage.
Anyway: the reason I'm posting this thread is there is no power from the battery to start the car as I took the wires of from the existing isolator switch off which wasmounted to the bull bar that was on there. So I currently have a few wires hanging out but an unable to move the car, due to the isolator having no on switch because of it being disconnected.
How do I go about avoiding that isolator switch so I can get the ute started?
Please get back to me ASAP as I'm going away for 3 weeks.
2008 GU CAB CHASSIS 3.0L ZD30
Supercheap Auto Member / Apprentice Mechanic
... Now there's a solution!
-
-
13th December 2012 02:14 PM
# ADS
Circuit advertisement
-
13th December 2012, 02:22 PM
#2
Smart like tractor
just reconnect the cables to the isolator if it is on the bullbar its probably an ex mine vehicle which is a battery isolator
96 GQ coil/Cab
08 G6eT
-
-
15th December 2012, 12:04 AM
#3
Advanced
All fixed now,
I have the bullbar off because I need a piece grinded off.
The trouble was that the isolator had no earth. I have 2 isolators hooked up, one inside of the engine bay and one on the bull bar.
The one inside was feeding positive from the battery, so disconnected it and ran a negative and earth to the existing wires from the bullbar isolator and connected them with a bolt and taped them up!
Good as gold...
2008 GU CAB CHASSIS 3.0L ZD30
Supercheap Auto Member / Apprentice Mechanic
... Now there's a solution!
-