Fixed the clunk coming from front axil, removed front sway bar..
Then went out and flexed up the new setup..
With rear engaged.
And factory rear disconnected.
Kallen Westbrook
Owner of
Westy's Accessories
Fixed the clunk coming from front axil, removed front sway bar..
Then went out and flexed up the new setup..
With rear engaged.
And factory rear disconnected.
Kallen Westbrook
Owner of
Westy's Accessories
Cheers
Kallen Westbrook
big_fletch (9th November 2012)
Whilst I might not have installed the drawers (free install from the Sydney 4wd show...) I did put the drop slide in.
Was a close fit. Check the build thread for the tolerances.
Last edited by teno45; 10th November 2012 at 01:04 AM.
Teno's Troll...
08 CRD ST. 2" lift, 33' Maxis Bighorns, Snorkel, ARB Deluxe Bar with Foggies, 12000lbs Avenger Mako TDS with Synthetic rope.
I got red dust in my veins.
Check out My Rig here: Broken
Pics of Forum trips I've Been on:
Pizza at AB's - 2012 Knockwood - 2013 Krissos Place Australia Day - 2015 Pizza at AB's - March 2015 Pizza at AB's - May 2015 Dargo - 2015 Newnes - 2016
WARNING: Towballs used for recoveries can, and do kill people and damage property.
Biscuits (10th November 2012)
Muffler was rattling when loaded against something, Missus took it back to get rectified and gave it an all over cleaning, bloody dust was everywhere on the interior.
Publicly speaking to a private audience.
2011 GU8 ST 3.0 CRD, ARB Bullbar with IPF spotties, scrub bars and side steps, Snorkel, Dual Battery system, Waeco fridge, Turbo Timer, ARB Roof Rack with 5 IPF spotties across the front, Custom full Leather Bucket seats, DPchip, 3" Taipan exhaust, ARE Intercooler & scoop, Autron EGT/Boost and dual volt gauges, ARB front locker.
Washed her
------------
2008 GU 3.0 CRD Auto - Life's too short to eat bad food.
Today was a productive day..
Installed some sound deadener (poly quilt filling) in the rear doors.. This enhances the bass to nearly sub quality, and eliminates the sound heard outside..
Then ran my wire to the rear for my work light, and installed a fuse box for the fridge, spotties and work light..
Nice and clean now
Just a single positive wire to the fuse box, which runs a buzz bar threw the middle and the out either side..
Very neat and good for 50A continuous..
Kallen Westbrook
Owner of
Westy's Accessories
Cheers
Kallen Westbrook
I kicked mine for playing up.. lol
Sent from my GT-I9210T using Tapatalk 2
Oil change, fuel filter, new k&n air filter. Found my exhaust leak from the manifold thats tomorrows job. Will also be putting the 31" tyres back on tomorrow for shits and giggles.
Prepping to do valve adjustments for tommorow
TD42 turbo GQ - ironman snorkel - 4 inch flexy coils - 6" shocks - 3" straight exhaust - pyro and boost gauges in A pillar- uhf - winch - sunraisers - Bluetooth - spotties - front lokka