Fitting a snorkel with gas.

[Dawso]

Mine is pretty agricultural, just drilled a hole in the airbox, screwed in a barbed fitting and epoxied it in place to seal.
Then ran some spare heater hose back to the converter.

If I get a chance I'll take some more pics.

It instantly sorted out the stalling issue and it ran beautifully on gas, needs a re-tune now though.

One thing I will say is to make sure when you install the snork, that you seal the entire intake.

Mine isn't sealed properly and I found dried muddy water in the intake after a recent trip to Tallarook.

Thanks for the pic Irish, where does the pipe connect to in the converter is there a single air intake on it?
Why does it connect to the dirty side of the airbox?