hey guys and girls here's my ute
3" ridepro suspension with heap of other gear to go along with it.
Running 35" Micky Thomson ATZ
roof console, upgraded to electric windows for personal comfort bit of a DIY.
up front iv had a mate cut up and brace the factory commercial bar to suit a WARN high mount,
iv modded the winch added the all favorable 6Hp warn motor, fill and drain holes on the gear box, braced the drum across the back to stop twisting, new seal kits and bearings, and 50m of 12mm dynamic rope.
Front and rear ARB air lockers running off dedicated compressor, whilst i was under there i got my hands on a set of 4.3 centre's and fitted them up as well
most resent addition is Marks 4wd adapters 43% reduction gears in the transfer case another DIY project that was getting to the pointy end of my knowledge and it was a good exercise just a hard job solo....
interior iv installed a pyro and boost gauge mounted on the A pillar, Recaro expert L drivers seat for ergonomics, in cab winch controls, UHF, el cheapo ebay navigation system runs oz explorer and igo for street nav.
more stuff im sure just a quick wrap.
ill try upload some pics
Birdsvile track
nice one in the desert the boss took
Pic of the high mount setup
In the run stuff haha
SA Coast line
Vic high country
gauge setup
hope you guys like the truck thanks
Brendan
Reply With Quote