Wiring Diagram: stop and rear turn lights...

[OzzieNorm]

My 2006 ST did not come (to me) with combo lights in the rear bumper. And the quarter panel lights do not contain indicators.
(The indicators are installed (after market?) on the top/inside the barn door windows.)

I have obtained genuine bumper bar light assemblies - but these came without globes/plugs/harness...
So, I need to wire up the stock lights that I have obtained.

There is no harness/loom on my Patrol for the rear bumper - so, I need to break into the main loom to get power.

Looking at the wiring diagrams in the manual:
1) On both pages EL-4059 and El-4060, the Stop lights have G/Y colour coded wiring.
2) On page EL-4078, the right turn signal have G/R colour coded wiring.
3) On page EL-4078, the left turn signal have G/Y colour coded wiring - the same as the Stop lights!!

Am I misreading the diagrams?

I have obtained a RHS combo harness from a local wrecker. It has 4 wires:
a) black with grey bands - Earth;
b) blue and black stripes - park/tail;
c) green and red - right turn signal;
d) green with yellow - presumably brake.

Where can I conveniently pick up power for the rear combo lights?

Thanks

[Yendor]

Your manual pages are different to mine, but if you look in the Harness layout.....Chassis harness, at the end of the EL section, on mine it is page EL-342.

You will see the two connectors you are after C10 and C12.

Or you could follow the wire harness to where they tapped into for the indicator on the RHS.