I used these on the GUIV running 28PSI and never had a problem with them
https://www.uniclamp.com.au/products...29c99014&_ss=r
I used these on the GUIV running 28PSI and never had a problem with them
https://www.uniclamp.com.au/products...29c99014&_ss=r
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
Been finishing off installing some gauges and bits in the top flap of center console GUIV, but out in came again to change e-locker switch... it gets easier
2008 GU WAG ST Manual CRD - To do the job
Hey, that's woken my brain up. How hard is it to remove the stock radio? I might be doing that soon.
..
2008 GU WAG ST Manual CRD - To do the job
mudski (19th June 2024)
Cluster all hooked up and even works. haha
Main and Aux battery V_meters w/2xUSB chg ports each.
Auber type gauges w/pyro measuring air temps in hot/cold side FM cooler.
Switch E-locker + a secondary isolator rocker around side of console.
Last edited by Bidja; 18th June 2024 at 10:13 PM.
2008 GU WAG ST Manual CRD - To do the job
BigRAWesty (18th June 2024), BrazilianY60 (19th June 2024), Cremulator (18th June 2024)
Finished wiring in all the lights.
I think I have enough..
Sent from my SM-S916B using Tapatalk
Cheers
Kallen Westbrook
Bidja (19th June 2024), BrazilianY60 (19th June 2024), Cremulator (18th June 2024), mudski (19th June 2024), Plasnart (18th June 2024)
Check this post out may help mate:
https://www.nissanpatrol.com.au/foru...418#post846418
2008 GU WAG ST Manual CRD - To do the job
New (used) non-leaking vacuum pump 110 amp altenator installed.
Also upgraded the wiring to the battery with 185 amp rated wire that has a 125amp midi fuse on the battery and one for the altenator side. Basically ripped off the idea from the Qikazz website and made it myself for a lot less with some stuff I had laying around.
IMG_20240721_110424485_HDR.jpg
Even got fancy with nutserts instead of tek screws.
IMG_20240721_124725877_HDR.jpgIMG_20240721_130403843_HDR.jpg
You can see the turbo is off while I was waiting for a turbo to dump pipe gasket from MTQ to arrive.
IMG_20240721_130924827_HDR.jpg
Last edited by gazq; 20th August 2024 at 09:33 AM. Reason: extra info
10G (20th August 2024), BrazilianY60 (20th August 2024), Touses (20th August 2024)