Search:

Hi all, I have a high flow Iron Man compressor that I bought back in 2018. A year ago I bought a set of Indeflate lines to inflate all 4 tyres at the same time. Well .. slow as a wet weekend. Took...

For those interested in the above intercooler and scoop. I have had between 80 and 100 degrees drop in EGT's since fitting in both around town and highway travelling. It was one of the hottest days...

the threaded rod I bought was enough to make 3 mounting points (2 from the rear seat anchors and one at towards the front (seen on the left hand side. Aluminium angle was used to give a mounting...

This is how it all turned out.
8813088131

I got a SM 8.8 that fits perfectly but need threaded rod. Doesn't have to be high tensile at all .. it's what is available that I will have to find out.

Went from the standard 31's to 33's in the tyre department a while back and it's so much nicer on road and off .. only issue is, she aint that great on the old hills any more (and that's without a...

I had the wobbles pretty bad and uneven tyre wear (outer edges). All mechanicals were fine ... had Tru Track in Bunbury W.A. throw in an offset bearing and it runs straight and true no matter what...

| also noted better fuel economy (i thought that around 10l per 100 was good), but now its around 8. Nothing else has been done (not even the service) between when the valves were installed and when...

Haha i bet it did. One psi higher on mine was an amazing difference .. she would only get to 14 psi prior to the vlaves going in. Im fine with that as its a long term vehicle for me and the missus

Hi all, just a quick note to tell you I have finally got around to having the Dawes and Needle valves fitted. Have kept stock boost level (15psi) which my stock patrol would only ever reach 14 no...

These are dedicated Auto electrics who both deal with redarc products .. they are both fully qualified and are not just the "installers" .. had enough of those clowns at the local Ironman dealership...

well bugger me ... I trolled for ages to try and find this out ... mind you .. I cant find anything on a shop shelf or in the cupboard either .. thanks for that :-)

haha .. oh how i wish :-)
well visited a local plastic supply shop who actually found a tiny torn off corner of a sheet of teflon that is perfect .. managed to punch 4 washers out of it .. so now ...

sure did .. engine idle .. running for several minutes ... maybe i need to creep forward for it to engage .. ?? just didnt want to do it on a hard surface .. might try when down the beach next

try this:
https://mrbodykits.com.au/collections/bonnet-scoop/products/mr-big-mouth-replacement-bonnet-scoop-suit-nissan-patrol-gu-series-intercooler-inatke-scoop?variant=31245105332302
I have...