Sounds like Limp.
Did u recently block the EGR?
Fit the Dawes and needle valve and for stock ECM(ecu) set the max boost no more than 16psi hauling (going up steep hill) in 3rd gear. For CRD using...
Type: Posts; User: Bidja
Sounds like Limp.
Did u recently block the EGR?
Fit the Dawes and needle valve and for stock ECM(ecu) set the max boost no more than 16psi hauling (going up steep hill) in 3rd gear. For CRD using...
Rear bracing looks strong as, see how the boxes can handle the flex _ user trial coming up.
Did u install the needle valve?
Should be able to run 15psi @ 3000rpm / 3rd gear hauling w/stock ECU _ wind it up a little (small bits at a time).
Did u try vac line connection direct to actuator...
Maybe thinking of a couple of angled RHS stays (L/R), running from near the top AFT sector of jerry carrier boxes down to the swing arm and even distributing the load along the back of boxes with RHS...
JD7902 something weird happening, just saw your last post but seems to have disappeared (deleted)_7.50pm.
Copied content from the email notification:
"Hi bidja Ive just installed the needle...
Noticed big improvement when I logged on around midday, takes say 1.5sec to get a "log on" to this page instead of 30+seconds.
So u done well AB _ hope it holds together mate.
Slow over the divide, thought it was my copper / ADSL
Deleted as double post
JD7902 I do not have first hand experience with this HPD Boost Controller, but it appears it is only to adjust for max boost without a spool rate means of adjustment.
Guess you want to add the...
Now 35,000 kms (3yrs back) did a CRD head gasket, while in there installed a new head (just in case) _ complete head assy from North Victorian engines (NVE/Cobram, Vic) no problems to date give them...
Morwong This thread was back in 2017 and Patrol girl was last on in 2018. Suggest u start a new thread, explain your eng fault symptoms, list any engine mods and the more info u provide will not be...
Maybe it is just a time thing.
So equally then hellgrace5, must be a good time to say G'day in the intro section.
Check this post out may help mate:
https://www.nissanpatrol.com.au/forums/showthread.php?56536-Center-Console-Fascia-removal-Radio-removal-simplified-pictorial-version&p=846418#post846418
Removal of the center console fascia GUIV and later _ how much later not sure.
Was asked how to access radio so knocked this up and may help others.
To remove center fascia:
Step 1 _ First...
There are a lot of copy Dawes boost controllers out there, the only one I trusted was the Dawes 3BarRacing manufactured (Black Body). Does not seem to be available now, lost mine and still sad...