OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: Tartrekka

Search: Search took 0.00 seconds.

  1. I had fully fitted covers, ie front back and...

    I had fully fitted covers, ie front back and sides, with cut outs for the airbags made by a company in Woolcock St Townsville...THE WOOLY FLEECE. There were also in built map pockets in the rear and...
  2. Replies
    1
    Views
    2,410

    After hefty bill from the stealership my problem...

    After hefty bill from the stealership my problem is solved. It was a faulty Rotary Position Sensor situated at the front of the transfer case. It is easily accessible, part only cost was just under...
  3. Replies
    1
    Views
    1,847

    Transfer case Y62

    Hi guys . Has anyone done an oil change on their transfer case .? If so what fluid did you use and did you have any problems doing the job.

    There appears to be problems finding an equivalent...
  4. Replies
    1
    Views
    2,410

    4WD light on dash

    Yesterday I jumped into the vehicle to back out of the garage. I noticed the 4WD indicator light on the dash on. The round switch on the console was in the usual auto position and the vehicle drove...
  5. Replies
    0
    Views
    2,410

    Oil burning/Timing chain rattles

    Has any body experienced either of these symptoms in the earlier series 1 vehicles? It appears to begin at about 70K on.
  6. Thread: e10

    by Tartrekka
    Replies
    6
    Views
    9,544

    E10 is hygroscopic. It collects water which will...

    E10 is hygroscopic. It collects water which will sit in the bottom of the tank and eventually cause rust. It also has adverse effects on some types of seals thus causing fuel and oil leaks. Premium...
  7. Replies
    1
    Views
    2,986

    Hi Craigg Yes I replaced mine in my 4.8 but...

    Hi Craigg
    Yes I replaced mine in my 4.8 but lashed out and purchased the platinum ones.Yes there is a gasket you need to purchase. It is the inlet manifold to block. It is shaped like a pair of...
  8. Hi Livelife. Might be in your best interests to...

    Hi Livelife. Might be in your best interests to get onto Nizzbits. Google them and ask about your problem. I have found them excellent.
  9. Welcome to the forum Iyad. If you read your hand...

    Welcome to the forum Iyad. If you read your hand book it should tell you to place the Nissan emblem on your remote over the start button and push. You may need to do this for success.
  10. Perhaps I am a sceptic but I can't come to grips...

    Perhaps I am a sceptic but I can't come to grips with why they or any other manufacturer would extend a warranty. My first thought is that while manufacturers are squeezing the dealers and their...
  11. Replies
    1
    Views
    7,751

    Auto Trans and towing

    I Have done just on 80k now in 4 years with half of this towing. I changed the auto trans fluid at 40k and it showed discolouration but was not burnt. I did another change a couple of weeks ago and...
  12. Replies
    0
    Views
    941

    Y62 front sensor issue

    Hi guys. My front sensors in centre of the bar activate at startup with nothing in front and do not shut off till 20kph. Is there a Y62 owner who can come up with a fix for the problem. Hope someone...
  13. Thread: G'day all

    by Tartrekka
    Replies
    4
    Views
    1,170

    G'day all

    G'day all. My name is Ian and I am a Y62 and GU 4.8 owner. I am pleased to join your forum.
  14. Replies
    4
    Views
    1,069

    G"day all.My name is Ian and I am a Y62 and a GU...

    G"day all.My name is Ian and I am a Y62 and a GU 4.8 owner. I am pleased to join the forum.
Results 1 to 14 of 14