OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 14 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    871
    Views
    476,639

    What a crazy day. Installed the water trap, then...

    What a crazy day. Installed the water trap, then the lift pump would not draw through it. I left it running on prime for 10 minutes, bowl remained empty. Anyway decided to fire the engine up and it...
  2. Replies
    871
    Views
    476,639

    Just added a full awning wall kit to the Visa...

    Just added a full awning wall kit to the Visa Card - oh the noise is coming I can feel it!!!!

    The Cruise control is more the annoying issue. It may go away with the road trial, but based on...
  3. Replies
    871
    Views
    476,639

    What you can be assured is that everything will...

    What you can be assured is that everything will be solved or it gets ripped out. Its been a journey and no, I dont intend selling it. The bee stings are all but exhausted I think. I know where all...
  4. Replies
    871
    Views
    476,639

    Ok, had some great technical support from the...

    Ok, had some great technical support from the supplier of the re-badges flow meters - Scintex. I tried to remove the original units located in the impossible zone where I installed them, didn't...
  5. Replies
    5,697
    Views
    2,282,878

    Mate. Good saw, but watch the oil and fuel caps....

    Mate. Good saw, but watch the oil and fuel caps. You must make sure you seat them properly and lock them. I have dumped a couple of tanks of both, by not concentrating on that job.
  6. Replies
    5,697
    Views
    2,282,878

    Nice saw, interesting model as well. I just got...

    Nice saw, interesting model as well. I just got my 066 and 230 back from a birthday, told the serial number on the 066 is 30yrs vintage! Its still got enough compression to pull the arm socket out...
  7. Replies
    871
    Views
    476,639

    Took a bit of quiet time yesterday to concentrate...

    Took a bit of quiet time yesterday to concentrate on the replacement AP60 Cruise control system I installed after munching the original up with a shredded belt. I have not been able to get it to...
  8. Replies
    22
    Views
    4,065

    Great to see you're still about mate.. Sent...

    Great to see you're still about mate..

    Sent from my Pixel 7 using Tapatalk
  9. Replies
    13
    Views
    5,831

    If a D shackle and your soft shackle will not fit...

    If a D shackle and your soft shackle will not fit through the hole, I question whether the point you are using is a true recovery point. I would be VERY careful here.
  10. Hell yes. Find all the earth straps and cables...

    Hell yes. Find all the earth straps and cables the undo the lugs, and clean the contact surfaces. I would also run a new earth from the body to the chassis at the front and rear. If it doesn't fix...
  11. I've had my pan off quite a few times since I've...

    I've had my pan off quite a few times since I've owned my Patrol and I've never seen any reason to replace the bolts and I've never had issues with leaks.
    I don't understand what they mean by...
  12. Replies
    30
    Views
    22,817

    So we decided on hahndorf, it was a good choice,...

    So we decided on hahndorf, it was a good choice, very busy down the main street. Just to break up the drive and because we haven't been there before we stopped in Mount Gambier for the night before...
  13. Replies
    462
    Views
    255,874

    I would move to warmer location in a heartbeat if...

    I would move to warmer location in a heartbeat if I didn't have so much family in SA
  14. Replies
    30
    Views
    22,817

    Got into Kalgoorlie pretty late so only had the...

    Got into Kalgoorlie pretty late so only had the next day to look around. So much to see.

    Big day driving from Kalgoorlie to mundrabilla roadhouse 830 KMS which was home for the night.

    Next day...
  15. Yet to buy and replace engine and transmission...

    Yet to buy and replace engine and transmission mounts, but some update: my rev counter on the dash only worked when it wanted and I have gone through the trouble of tracing all the harness down to...
Results 1 to 15 of 200
Page 1 of 14 1 2 3 4