OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 4 of 6 1 2 3 4 5 6

Search: Search took 1.00 seconds; generated 37 minute(s) ago.

  1. Thread: Cuppa’s Blog

    by Cuppa
    Replies
    291
    Views
    149,675

    A little corner of South Bruny Island...

    A little corner of South Bruny Island is 'heaven on a stick'.
  2. Replies
    7
    Views
    6,719

    I almost always drop the glove box out when...

    I almost always drop the glove box out when working up in that area... a few screws and 2 minutes and a lot less angst.

    The eleccy connector on the Sub Tank Computer is a PIA if you don't squeeze...
  3. Replies
    7
    Views
    6,719

    It should just come out mate. Remove radio...

    It should just come out mate.
    Remove radio surround and fascia .
    Remove the trim plastic from around the gear stick and i think its 2 screws from there it slides out.

    I may have photos from...
  4. Replies
    4
    Views
    2,020

    Is it a digital/electronic odometer or a manual...

    Is it a digital/electronic odometer or a manual rotary one?
  5. Replies
    4
    Views
    2,020

    There are too many legal hoops we have to jump...

    There are too many legal hoops we have to jump through to post a guide of that sort in here. :)
  6. Replies
    5
    Views
    2,341

    The stainless block plate on mine is the same...

    The stainless block plate on mine is the same thickness as the stainless gasket that was in there 👌🏼
  7. Replies
    5
    Views
    2,341

    In my opinion, Just block it. Whilst its illegal...

    In my opinion, Just block it. Whilst its illegal to block it, a thin blanking plate hidden is harder to spot than an entire removed EGR setup, if you ever get pulled up from the RTA...
    Leave the...
  8. Replies
    16
    Views
    22,429

    G'day Tip12345 mate! Pic below of my 1999 GU ute...

    G'day Tip12345 mate!
    Pic below of my 1999 GU ute 'Extra Cab'
    72515
    Was done brilliantly by 'Laingley-WA' before our time together :-) Something like $10k+ minimum I believe drive in/drop off or...
  9. What about the inside out.....rod through block ...

    What about the inside out.....rod through block

    Sent from my SM-T355Y using Tapatalk
  10. Replies
    13
    Views
    19,096

    Howe did you go? Did you get it out?

    Howe did you go?
    Did you get it out?
  11. Replies
    13
    Views
    19,096

    Not really any idea on balance point. I dropped...

    Not really any idea on balance point. I dropped mine and it flaming hurt my shoulder.
  12. Replies
    13
    Views
    19,096

    I used a engine crane in the passenger door and...

    I used a engine crane in the passenger door and through the trans tunnel with a sling around the gearbox. Whilst it was still a bitch to remove, it was easier with the sling, than having it hard...
  13. Replies
    13
    Views
    19,096

    No no, removal is not really that hard once you...

    No no, removal is not really that hard once you know what to do.
    1. Undo all associated bolts including tail shaft.
    2. Unbolt and remove the shift cover from the top of the box. No chance with it...
  14. As Cuppa said, assuming you have a GU then unbolt...

    As Cuppa said, assuming you have a GU then unbolt the top of the Fuel filter bracket and move it out of the way and you will have a heap of room. I generally change the fuel filter while I'm there...
  15. Replies
    39
    Views
    61,595

    Probably depends how big your hands are. I unbolt...

    Probably depends how big your hands are. I unbolt the fuel filter bracket & unclip & move a couple of vacuum lines out of the way & can then just have sufficient rom to lift the old filters out.
Results 46 to 60 of 76
Page 4 of 6 1 2 3 4 5 6