Search:

It wasn't easy to find. Had to dig a bit but got there in the end. Glad it was what you needed!

I think this matches your unit?
...

Welcome mate. The list is a mile long. Have a look through the forum and you'll see things you like. Start a build thread too :)

Good job. You were going to be up for $ one way or another. Rolled the dice and came up 7s haha

Not that I recommend it.. But I bent mine to get the room I needed. I only ran a 3in though, so it didn't need to move as far as that I think mine just needed a little wriggle room.. Not the 2in it...

I have one of these; (a dewalt impact driver)

https://www.ebay.com.au/itm/323816538417

With a (much better set than the link) set of these adapters;

https://www.ebay.com.au/itm/193447162270...

I had a bit of a google and looks like there's a cold start feature that can be deleted that has pipes and sht going everywhere.

I'm betting it's all related to that.

A. I dont know. Post up your engine type and hopefully someone else might be able to assist.

B. You've checked globes? Checked you get power at the plug for the globes? If the globes and plugs are...

Close enough. Welcome mate.

I think what he's saying is only run it at a boost level your fuel pump can support or you'll start to lean things out and your egt's will be too high.

My understanding is that for throttle...

I have a little 1/4in dewalt impact driver rated at 200 something nm. Not designed for that but I have rattled a wheel nut off before.. It wasn't exactly expedient and I thought it was going to sheer...

Mines a steel rack and I reckon I added about 1lt/100 when I bolted it on. It's just too dam handy though.

Not sure on the 2.8.. But the 4.2 won't show fuel at the injectors if the fuel stop solenoid doesn't have power.

It's on the wish list mate. I'd take it off your hands if I could!

Saw these today and thought might be worth having one in the toolbox for $9

Probably nothing new but I've never seen them. May find a use for it.

80665

80666