It might not be ground loop - could be RF interference. (could also be Winnie's issue)
Try a different brand USB adaptor.
We have had issues with sat phone kits at work causing interference as...
It might not be ground loop - could be RF interference. (could also be Winnie's issue)
Try a different brand USB adaptor.
We have had issues with sat phone kits at work causing interference as...
bloodyaussie - how far apart do you have the antennas -if the antennas are too close it will affect you radioation partern and can result in higher VSWR.
I always have a good laugh when i see...
re your orginal question:-
We have had some issues with sat phone kits casing interferance at 150Mhz.
if you find that your cb rx souns noisy or you seem to have trouble receiving - try...
I use toilet paper to clean up - roll per side and a shopping back to throw the used bits in.
I pulled the motor.
I didnt want to try lifting it by myself, as they are man killers.
I happen to own a gantry and a block and tackle - took me 2 days to replace the clutch - by my self.
...
I run sygic with my Samsung Tab2 - 7" (and play music), off road I run oziE.
Its ok
I mainly use polar and RFI - preferance being RFI - depends on the application.
The RFI Elevated feed GPI and Mopole GPI antennas are great. The elvated feed where orginaly designed for emergency...
I got the xtral from work - it was on a old circuit board.
I only found a online mob in ebgland that had the 4.19 mhz on the sehlf. But as the 4.097 rock worked you might be able to get one that...
Have a look at http://mq-patrol.com/
I have had one for 2 years now - happy with it. The only thing I didn't like is the control box mounting is above the cable spool. First time I used it the control box mounting brackets were damaged....
The bigest advantage with ozi is that you can import your own maps.
I wrote an interface to ozi for radio coverage surveys. My app interfaces a tablet to a commercial radio that provides signal...
The mk rear doors may fitt - but it would involve some manufacturing for the hinge mounting points etc.
I had similar problems.
Removed the ballast resistor and changed the coil to a gt40 - still intermittent misses.
Found the advance ring in the dzzy was seized - cleaned and greased it -...
Sorry for the dig.
A MK h233b rear LSD will fit into the front of a gq.
I need to drill the ring gear holes on the lsd as the GQ crown uses M14, while the MK H233b centre (lsd) uses M12 bolts
From the back of the PCB - it was near the top right corner - I pretty certain the board was labels on the component side.