Search:

Hi Lionel,
From what I can see, this is a very early SD33 NA., about 1980, the gearbox is not Nissan as is the transfer, the clutch could be anything, I'd say the Rover master cylinder would do the...

Injector pump control rod missing, Dash pot (vacuum controlled) missing from bracket next to inlet.
I would be hoping the inside of injector pump is better than the outside, and that as it has a...

The thing is Lionel, does yours have a rod or a cable?, rod is 24 and cable is 12v, but if it's 12v it would most likely have a turbo!
Cheers the ferret.

Yeppum, that's the Edic motor, SD 33 non turbo 24V, darn!!
When you turn the key on, the motor moves a rod at the injector pump, firstly to "start" position then to "run", when you turn key off, it...

Nah, I'm here fer good Rodney,
I do get pleasure out of helping others tho, as I'm sure you do.
Cheers, the ferret.

Hey fruitloop, just stick the overalls on and go and find the turbo nuts jammed in behind the starter, he might buy you a beer!!
Cheers, the ferret.

Turn the "heat " switch off, r/h side of dash.
Cheers, the ferret.

Hi Rodney, how's it going Mate?
I have an SD33 NA in the boat, it was 24V, is now 12V, and I have a cable with a 3 position Detent to operate the injector pump, pain, but better than the Edic motor...

"The boy stood on the burning deck, his pocket full of crackers
one......................darn, fergot agin
cheers, the ferret.

Hmmmmmm, that's a worry lol.
Cheers the ferret.

Hey Fruitloop,
I know mate, and it's not your fault that the poo has hit the rotating blades, it's noble of you to sort the repairs as anyone else would responsibly do.
BUT ya must get it right...

All good there Fruity, that's what this forum is all about, helping others, right from the get go Andy wanted this forum to be different in that there was no bitching among members, the plan was to...

Fairy tale



Once upon a time, a Prince asked a beautiful Princess, "Will you marry me?" The Princess said, "No!!!" And the Prince lived happily ever after and rode motorcycles and dated...

@ fruitloop, chemiweld is like a bandaid on sore thumb, it only washes off.
Get the head crack tested, use new head studs, check liner protrusion before fitting the head.
This way, you may have a...

Hey Fruitloop, re your SD33T, if the motor was turned over, even by hand when the head was off, there is a chance that the cylinder liner has moved, they rely on a tiny seal at the bottom of the...