Search:

Got to be real careful to not scratch the plastic, but to actually polish it. The reason they go cloudy is from a build up of old Polish and wax and dirt. So all you want to do is remove that.

I...

Holy hell. They must of absolutely belted the bejeezus out of them

Give it clean up with a wire brush. Should just easily slide on and off.

That works. I have found that the boot is easier to pinch while trying to get the piston in, but in saying that there is more then one way to skin a cat, and my methods aren't always the best

Trick to get the pistons out, use compressed air. In little squirts other wise they go flying. Try stop them completely coming out as it will only push 1 out, then be a pain to get the other side...

I used the same kit on mine just the other week. Seems to be holding up well

As mentioned shooting in both raw and jpg will fill your memory card up super quick. I think I can get around 1000 photos on raw (canon 70D 32gb?? Card), few hundred more with just jpg but can only...

Just remember when you do make a decision about the camera, it's not the megapixels number that counts, it's the quality of the image processor (the bit that actually "takes" the photo, or where the...

FWIW My patrol got hailed on and it was only 6k total. Thats hail repair and door shut (only the exterior) paint.

Im all for giving things a crack, hell i want to paint some stuff on my missus...

I'll 2nd bolsys. Very well put together sliders. I have dropped my car on them hard several times and they are still good as new.

Tbh it's cheaper to get it properly fixed before it destroyes itself.

Could just put a wrecker box in in the mean time until funds allow but then you are running the risk that it's in sh!tty...

I had it done at a shop as it actually broke down. Reason being all the bits of torque converter blocked the cooler and melted everything.

Had I gotten it rebuilt before melting everything, would...

When you checked the fluid, did you check it off the dip stick or off the drain plug?

If i can remember correctly my auto had a similar sound, metally rattley kind of sound, and it was the Torque...

Must of had your wheties for breakfast.

They may of already been weakened/damaged. Should be fine in 2wd for now. Change before you need 4wd drive though.

I welded a round head bolt to the brackets on my light bar and also used nylock nuts. The bolts are annoyingly long (couldn't be bothered cutting them down) so you need to use long sockets. They also...