Search:

did the mod on my GQ. A 3K resistor was a bit too much, gear change from 1-2 was too harsh so settled with a 1.2k resistor. 1-2 ans 3-4 noticeably faster, 2-3 quicker too, but still a bit sluggish. A...

PTC heater is only fitted on RB30 Patrols. It's the heating element mounted under the carby.

http://i758.photobucket.com/albums/xx224/tonyh01/IMGP0559.jpg

Tony

Boggy2006,

You don’t need to access the TCU for this mod. Both wires are the 2 that go to the plug for the voltage dropping resistor.
The TCU is behind the passenger side kick panel.

and another for you Ripper

http://forum.patrol4x4wa.com/index.php?topic=2075.0

cheers

Hey metty.

This should give you a few ideas, I hope.

http://myswag.org/forum/index.php?board=7.0

http://myswag.org/forum/index.php?board=28.0

Ross
DX grunt

The external part of the swivel housings don't need to be lubricated, any wet lubrication like grease or oil will only trap dust and turn into grinding paste.
To check swivel hub bearings you can...

hey dude i have those 2 washers pm me your address and ill post them to you if you want

Sorry to be a bit slow responding, I've been down in the shed.

My manual shows 2 washers between the rocker and the 2 bolt pedestal, at least one of the washers is a wave washer.

Tony

Check the width of the rest of the rocker arms, maybe someone has mixed them up, I know that on the sd33 they all look the same but they are not, maybe there is a wider one that should be there, and...

Linley, you may not know much about cars or computers, but you tell a good story. You're going to fit in well around here.

To put full size photos (I set my photo size at 640 x 480)in you posts...

Vehicles affected; all Patrols with plastic engine fan, which is all GQ and GU.

The engine driven cooling fan on Patrols is made of plastic (apart from the steel hub that bolts to the viscous...