Search:

I like reading these threads, some of you guys are pretty damned good at this sort of stuff.

Hmm, maybe it's for a sensor somewhere. Probably don't need it if the Guage works all good. You could try giving Jono a pm or he might see this, his was an TBE although he went the full loom swap. ...

Hi Andy, there's just one wire that goes to the temp sender (just next to the thermostat housing) on both TD &TB ( unless the TB E is different, mine was a carby). I just put a new terminal on and...

hey mate great pics. Bugger about the manifold. Can't wait to hear it running.My conversion is just about to start,and i will use a lot of your useful information So thanks for all the info.

Hi, hows the conversion going? I'm just starting the same sort of project except i bought the whole car and am giing from tb42 manual on gas to turbo td42 automatic.
Is yours up and running yet or...

The special timing tool what does it look like and why 0.76mm @TDC

Nice.......

Just wind the engine over until the piston is at the lowest point. Then just gently maneuver until they are central.

Works case scenario on being misaligned is they bend or break and provide no...

If you have fitted turbo pistons, there is a small hole the tip needs to point into. The oil goes through the crown on turbo ones, N/A ones it just points at the bottom of the crown.

I found mine...

Did you check the squirter alignment?

I think I once asked this question and the answer was that there is no point.
But can't remember why lol..

It will come together... its hard to be patient I know!!!!

Great thread and write up mate. Very interested to see how this all comes out. Good luck with the rebuild and conversion sounds like a great project. :D

Lucky you nice gift

Ahh yes silly me, I had forgotten that we spoke. I just left my ECU in, it doesn't bother me sitting there.

I'm from the northern suburbs but I'm down in Mt.Eliza/Frankston quite a bit so if...