Search:

Geez, I would have thought the turboed 4.2 should pull the van with no issues. These motors have heaps of torque down low.
Sounds like a good tune is in order.

I tow a 2.7T van with my 3L and...

From memory I did it with just the lower section removed from the shroud.
I did remove the complete shroud when I replaced the radiator, it wasn't that hard to do, changing the belt when the...

It may,,,,,may remember the state of the MAF when dirty
so disconnect it so it starts fresh with better values,
does that sound right

I would say you may have missed a wire to the motor. Either the earth wire, solenoid wire or the thick +12V wire from the battery. Earth wire is usually the body.

well this might take a bit of time to get this onto the forum but not as long as it was to save the girl
it all started back in 2000 for a 1982 mq patrol (just like the one my brother in-law had...

Typical starter motor has a main +ve terminal for high current to the motor, and a smaller +ve wire from the key start to operate a solenoid (relay) which connects the high current +ve to the starter...

Use the nut in the center of the tension pully arm, not the nut that bolts it to the engine. It is a different size. Put tension on it and hold it for a few seconds and wait for the tensioner to...

http://www.nissanpatrol.com.au/forums/attachment.php?attachmentid=63491&stc=1

I use a ring spanner on the tensioner and then use a ratchet strap that fits its hook into the other end of the ring spanner. The opposite end of the strap is wrapped around the passenger wheel. ...

Route the belt thru the A/C , Crank, Alt and Power Steering as best you can then back off the tensioner and slide the belt under the tensioner pully.

A socket breaker bar is usually the best tool...

Sold my Patrol today, so I won't around here anymore.

Good website. Good luck to all of you and have a good Christmas and New Year.

PS. I may pop in every now and then to play with the Chrissy...

actually, did a little more digging -rather than give you the wrong info - heres the exact spec from the service manual
...

Hey mate,

If you wanna check its definitely the light and nothing mechanical theres an easy test:
find a car park or somewhere you can turn the truck around easily, put it in 2 wheel drive, turn...

Big job or easy once you have the right tools
Heres a link to the 33 spline tool

...

I only changed the pulley, had to get a 33 splined tool (about $8) to remove and install it.
My youngest son has a compressor and borrowed a rattle gun for the job.

I ended up using a...