OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 3 of 12 1 2 3 4 5 6

Search: Search took 1.00 seconds; generated 45 minute(s) ago.

  1. GQ manual - including TB42e ECU details - Not in english

    Hi,

    I have been searching for the TB42e wiring details.

    i found this manual - has all the gq motors - including the TB42e ECU details - (see page 108 onward)

    Its not in English, but the...
  2. Replies
    39
    Views
    19,991

    We had issues with the 4.2 diesels at work...

    We had issues with the 4.2 diesels at work causing RFI interference In the 150 - 172 mhz freq's. Your fault sounds similar - uhf CB is at 476 Mhz.

    We traced the issue to the ECU, we had some...
  3. Thread: L28 Problems

    by GQ TANK
    Replies
    2
    Views
    1,365

    Try bleeding again, they can be a bugger to...

    Try bleeding again, they can be a bugger to bleed.

    You might need to put a kit though the carby, try some carby cleaner first

    Im assuming you put your foot down and hold it down, it revs out...
  4. Thanks all - was a great meet-up

    Thanks all - was a great meet-up
  5. Replies
    5
    Views
    2,418

    The l28's can go hard - a sd33t will go a lot...

    The l28's can go hard - a sd33t will go a lot harder.

    If you can pick up a donner vehicle it would be a reasonably cheap mode.

    You may make it hard to find a l28.

    I put a rb30 in my old MK -...
  6. Replies
    238
    Views
    514,387

    Sticky: Missfiring, rough idle and rough running This...

    Missfiring, rough idle and rough running

    This can also be caused by the a loose carby. in the base of the carby there are 3 screws that join the butterfly assembly to the rest of the carby, they...
  7. Replies
    29
    Views
    14,484

    My tb42 has a simalar issue when I first got ir -...

    My tb42 has a simalar issue when I first got ir - then it stoped working on petrol.

    I ut a kit though the carby.

    The rb30s and tb42s carbys are basically the same - they even use the same kit.
  8. Replies
    8
    Views
    3,343

    Could be an issue with the PCV valve (air...

    Could be an issue with the PCV valve (air sucking noise)

    The PCV sits on the inlet manifold between the manifold and the carby. There is a pipe coming up from the PVC valve that goes to the...
  9. Replies
    9
    Views
    4,374

    The rf supressor will stp rf interferance to you...

    The rf supressor will stp rf interferance to you am / fm radio and CB
  10. Replies
    9
    Views
    4,374

    You need to remove the condensor. With a GT40R...

    You need to remove the condensor.

    With a GT40R you need to have a ballast resistor.

    If you upgrade to a gt40 or a pertonix coil - then you remove the ballast (just connect all the wires...
  11. Thread: speedo sensor

    by GQ TANK
    Replies
    2
    Views
    1,579

    Have a read of this post as it gives some info...

    Have a read of this post as it gives some info about testing

    http://www.nissanpatrol.com.au/forums/showthread.php?27775-GQ-Speedo-reads-overspeed-sometimes&highlight=speedo
  12. Replies
    24
    Views
    10,585

    As I was working in NZ at the time - it would...

    As I was working in NZ at the time - it would have been a bit hard to explain to assie customs
  13. Replies
    24
    Views
    10,585

    I remember about 18 years I go i went to a gun...

    I remember about 18 years I go i went to a gun show in Auckland. I could have brought a 20 mm anti aircraft gun along with a couple 100 rounds of ammo.
  14. Replies
    24
    Views
    10,585

    Hmm might not be a good idea to list your...

    Hmm might not be a good idea to list your firearms.
  15. Replies
    17
    Views
    5,272

    If it was rf you would notice the power...

    If it was rf you would notice the power increase/decrease depending on what your phone is doing or where its located = yes if its from the rf side of the phone.

    I was thinking more of the dc -dc...
Results 31 to 45 of 172
Page 3 of 12 1 2 3 4 5 6