Search:

High EGTs, Guess this with eng under high load / hauling?

Important to rule out any vac or boost faults / issues first. Good to get boost gauge working.

What boost control method do u use?
...

Just to add here, do a quick check of VNT actuator function (vacuum):

at idle, is the actuator rod in the raised position, ensure that the lever is resting against vane limit stop screw? yes/no...

This is the filter I installed recently bought from NIZZBITS_ AU $59 (Genuine Y61 GUIV) and came with the securing clip but cost more than your AU $10 "choina one"
...

Getting some good saw logs from the old red stringy bark that came down last week _ ground being saturated and heavy windage.8621286212

MB Blood_rusty moon pic with good old shaky mobile phone over above back paddock but the evening shy is eerie.

Other side of the divide. Check this out (Monday 31st), heaps more rain, with water table rising now thru to surface level and the 6 meg dam has 80m long wall with I m free board and she breached...

mudski, a couple of pics that might help give you some ideas. Check em out and can discuss if u want.

Posts being cemented in the ground will depend what is down there, alternatively you could...

I would look at utilising the H posts as well (depending on how they are secured _ in ground with concrete / yes). Maybe use some angle section or similar "profiled up" or off the shelf brkts, so...

Mark, Ramset make a chemical anchor systems (Chemset 101 and 502) and they do supply in spin capsule which would be best option for you. For use of the Ramset cartridge you need their dispenser...

Multi bin quick fill method, beat square mouth shovel and wheel barrow effort:smiley_thumbs_up:.

New Kubota 50HP tractor paid and was delivered today. More practice but goooood thing. 4cyl turbo diesel, H/L range (total 8 gears_Fwd and R_manual) 2/4wd with rear diff lock.

TEA20 RIP will see.

Getting a new tractor as my old Fergie TEA 20 has blown out a piece of block side casing due to coolant freeze/expansion past winter. Time to retire it to shed for rebuild latter yrs.

Just paid...

CRD has two TPS (TPS 1 & 2). CRD drive by wire, I understand that one TPS is for pedal and second for throttle body. Not sure of actual location of each of the TPS (TPS 1 and 2), if you find out I...

Open face notch but looking at the Humboldt Notch it appears to provide a vertical shear face that would help prevent kick back at cut and read that is more suited for timber that is likely to split...

My weekends are longer now that I am retired (so called).

Clearing the way for the new shed(few more days yet).